Poulan 960120068 manual Check Battery See Fig

Page 7

ASSEMBLY

	SEAT	SHOULDER
	SEAT	BOLT
		BOLT
	SEAT PAN
	FLAT WASHER
	LOCK WASHER
		02465
	ADJUSTMENT
	BOLT

FIG. 2

CHECK BATTERY (See Fig. 3)

•Lift seat pan to raised position.

•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in MAINTENANCE section of this manual for charging instructions).

SEAT PAN

LABEL

TERMINAL

TERMINAL

FIG. 3

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

TO ROLL TRACTOR OFF SKID (See Op- eration section for location and function of controls)

•Press lift lever plunger and raise attachment lift lever to its highest position.

•Release parking brake by depressing clutch/brake pedal.

•Place gearshift lever in neutral (N) position.

•Roll tractor forward off skid.

•Remove banding holding deflector shield up against tractor.

TO DRIVE TRACTOR OFF SKID (See Op- eration section for location and function of controls)

•Be sure all the above assembly steps have been com- pleted.

•Check engine oil level and fill fuel tank with gasoline.

•Sit on seat in operating position, depress clutch/brake pedal and set the parking brake.

•Place gear shift lever in neutral (N) position.

•Press lift lever plunger and raise attachment lift lever to its highest position.

•Remove key from bag and start the engine (see"TO START" in the Operation section of this manual). After engine has started, move throttle control idle (slow) position.

•Depress clutch/brake pedal into full “BRAKE” position and hold. Move gearshift lever to 1st gear.

•Slowly release clutch/brake pedal and slowly drive tractor off skid.

•Apply brake to stop tractor, set parking brake and place gearshift lever in neutral position.

•Turn ignition key to “OFF” position.

Continue with the instructions that follow.

7

Image 7

Contents Model PO15538LTGeneral Operation Safe Operation Practices for Ride-On MowersII. Slope Operation IV. Towing ServiceGeneral Service III. ChildrenTable of Contents Contents of Hardware Pack Unpack Carton Tools Required for AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Battery See Fig Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Transport Reverse Operation System ROSTo Operate Mower See Fig To Operate on HillsTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips Lubrication Chart MaintenanceBlade Removal See Fig TractorTo Sharpen Blade See Fig Transaxle Cooling BatteryEngine BeltsMuffler CleaningClean AIR Screen AIR FilterTo Remove Mower See Fig To Install Mower See FigBelt Removal To Level Mower HousingBelt Installation To Replace Mower Blade Drive Belt See FigTo Check Brake To Check and Adjust Brake See FigTo Adjust Brake To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigTo Start Engine with a Weak Battery See Fig To Adjust Steering Wheel ALIGN- MentTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorCylinders OtherFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when Limited Warranty Service Notes Fold Alon This Dotted Line REE Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service Changere DE Pièces LES ET L’ENTRETIEN UNE Pliez EST Ceci Degrés Suivant LESDentretien Notes Limitée Garantie Correction Cause Problème Dépannage DE GuideRalenti Moteur EntreposageRéglages ET Révision Vitesses DE Boîte LA DE Mentgechan CarrossageAVANT/ Roues DES Convergence DI LA DE L’ALIGNEMENT Régler Pour19 .FIG Courroie LA Remplacer PourFrein LE Régler ET Contrôler Pour Transmission DE MENTNETRAÎD’ENSedeuton Courroie Acer Rempl PourDE Boîtier LE Niveau DE Mettre Pour Tondeuse DE Lame DE MENTNETRAÎD’ENTondeuse LA Enlever Pour Tondeuse LA Installer PourReglages ET Revision TracteurAIR À Filtre Ligne EN Installé D’ESSENCE FiltreEntretien ’ALLUMAGE Bougie11 .FIG LubrificationTransmission LA DE Refroidissement Trapézoïdales CourroiesFig la Voir Lame LA Enlever Fig la Voir Lame LA AffilerEN Fonctionnement DE Système ET Utilisation Chaque Avant Recommandations LESGénérales Lubrification DE TableauTonte DE Conseils UtilisationMoteur DU D’HUILE Niveau LE Vérifier Moteur LE Démarrer DE AvantMoteur LE Démarrer Pour ’ESSENCE Réservoir LE RemplirPentes LES Dans Utiliser Pour Accessoires AutresET Charrettes DES Remorquer Pour Tracteur LE Transporter PourFig la Voir Mentnetionsta DE Frein LE Engager Pour GAZ DES Commande LA Utiliser PourTeurtrac E R T O V R E S I L I T U T N E M M O C Fig la Voir Arrêter Pour02829 Moteur Montage LA Voir Rouler Faisant LE EN Ette LA DE Tracteur LE Retirer PourDesmancom DES CON Pour Mentnetionfonc TionsecToncar DU Tracteur LE Sortir PourLE Pour Exigés Outils LES Palette LA DE Tracteur LE Retirer DE AvantSiège Direction de Volant Montar SIN PiezasPente-Guide ClésClient DU Responsabilités SommaireProduit DE Spécifications Général Entretien EntretienRemorquage EnfantsTracteurs des sécurité toute en l’utilisation pour Conseils PentesLES Dans Fonctionnement Général FonctionnementImportant Manuel