Poulan 425014X92E manual To Adjust Carburetor

Page 26

TO REPLACE HEADLIGHT BULB

1.Raise hood.

2.Pull bulb holder out of the hole in the backside of the grill.

3.Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

4.Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL AS- SEMBLY

1.Raise hood.

2.Unsnap headlight wire connector.

3.Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

4.When replacing hood, be sure to re- connect the headlight wire connector.

Hood

Headlight

 

Wire

 

Connector

 

01536

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be nec- essary. Check adjustment as described below before loosening cable. If adjust- ment is necessary, see engine manual

TO ADJUST CARBURETOR

The carburetor has been preset at the factory and adjustment should not be nec- essary. However, minor adjustment may be required to compensate for differences in fuel, temperature, altitude or load. If the carburetor does need adjustment, see engine manual.

26

Image 26
Contents Tractor Model Product InformationTable of Contents General Operation Safety RulesOwners Information II. Slope Operation III. ChildrenIV. Towing Service Safe Handling of GasolineGeneral Service API-SG-SL Product SpecificationsCustomer Responsibilities U1RUnassembled Parts Before Removing Tractor from Skid Tools Required for AssemblyTo Remove Tractor from Carton Check Battery Check Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS Using the Reverse Operation SystemTo Operate Mower Before Starting the Engine To Start Engine Mowing TipsBefore Each USE MaintenanceGeneral Recommendations Lubrication Chart Tires TractorBrake Operation Blade CareEngine Cleaning To Remove Mower Service and AdjustmentsTo Install Mower To Level Mower Housing SIDE-TO-SIDE AdjustmentTo Check and Adjust Brake To Replace Mower Blade Drive BeltTo Replace Motion Drive Belt Transaxle Gear Shift Lever NEU- Tral AdjustmentTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN/CAMBERTo Remove CABLES, Reverse Order Replacing BatteryTo Remove Wheel for Repairs To Start Engine with a Weak BAT- TeryTo Adjust Carburetor Fuel System BatteryOther Engine OILTroubleshooting Chart Problem Cause CorrectionExcessive Mower blades will Suggested Guide for Sighting Slopes for Safe Operation