Poulan 425014X92E manual Mower blades will

Page 30

TROUBLESHOOTING CHART

 

PROBLEM

CAUSE

CORRECTION

 

 

 

 

 

 

 

Mower blades will

1.

Obstruction in clutch

1.

Remove obstruction.

 

not rotate

 

mechanism.

 

 

 

 

2.

Worn/damaged mower drive

2.

Replace mower drive belt.

 

 

 

belt.

 

 

 

 

3.

Frozen idler pulley.

3.

Replace idler pulley.

 

 

4.

Frozen blade mandrel.

4.

Contact a qualified service

 

 

 

 

 

center/department.

 

 

 

 

 

 

 

Poor grass

1.

Engine speed too slow.

1.

Place throttle control in

 

discharge

 

 

 

“FAST” position.

 

 

2.

Travel speed too fast.

2.

Shift to slower speed.

 

 

3.

Wet grass.

3.

Allow grass to dry before

 

 

 

 

 

mowing.

 

 

4.

Mower deck not level.

4.

Level mower deck.

 

 

5.

Low/uneven tire air

5.

Check tires for proper air

 

 

 

pressure.

 

pressure.

 

 

6.

Worn, bent or loose blade.

6.

Replace/sharpen blade.

 

 

 

 

 

Tighten blade bolt.

 

 

7.

Buildup of grass, leaves

7.

Clean underside of mower

 

 

 

and trash under mower.

 

housing.

 

 

8.

Mower drive belt worn.

8.

Replace mower drive belt.

 

 

9.

Blades improperly installed.

9.

Reinstall blades sharp edge

 

 

 

 

 

down.

 

 

10. Improper blades used.

10. Replace with blades listed in

 

 

 

 

 

this manual.

 

 

11. Clogged mower deck vent

11. Clean around mandrels to

 

 

 

holes from buildup of grass,

 

open vent holes.

 

 

 

leaves, and trash around

 

 

 

 

 

mandrels.

 

 

 

 

 

 

 

 

 

Headlight(s) not

1.

Light switch is “OFF”.

1.

Turn light switch “ON”.

 

working

2.

Bulb(s) or lamp(s) burned out.

2.

Replace bulb(s) or lamp(s).

 

(if so equipped)

3.

Faulty light switch.

3.

Check/replace light switch.

 

 

4.

Loose or damaged wiring.

4.

Check wiring and connections.

 

 

5.

Blown fuse.

5.

Replace fuse.

 

 

 

 

 

 

 

Battery will not

1.

Bad battery cell(s).

1.

Replace battery.

 

charge

2.

Poor cable connections.

2.

Check/clean all connections.

 

 

3.

Faulty regulator

3.

Replace regulator.

 

 

 

(if so equipped).

 

 

 

 

4.

Faulty alternator.

4.

Replace alternator.

 

 

 

 

 

 

 

Engine “backfires”

1.

Engine throttle control not

1.

Move throttle control

 

when turning

 

set between half and full

 

between half and full speed

 

engine “OFF”

 

speed (fast) position before

 

(fast) position before

 

 

 

stopping engine.

 

stopping engine.

 

 

 

 

 

 

30

Image 30
Contents Tractor Model Product InformationTable of Contents Safety Rules Owners InformationGeneral Operation II. Slope Operation III. ChildrenService Safe Handling of Gasoline General ServiceIV. Towing API-SG-SL Product SpecificationsCustomer Responsibilities U1RUnassembled Parts Tools Required for Assembly To Remove Tractor from CartonBefore Removing Tractor from Skid Check Battery Check Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Using the Reverse Operation System To Operate MowerReverse Operation System ROS Before Starting the Engine To Start Engine Mowing TipsMaintenance General Recommendations Lubrication ChartBefore Each USE Tires TractorBrake Operation Blade CareEngine Cleaning Service and Adjustments To Install MowerTo Remove Mower To Level Mower Housing SIDE-TO-SIDE AdjustmentTo Check and Adjust Brake To Replace Mower Blade Drive BeltTo Replace Motion Drive Belt Transaxle Gear Shift Lever NEU- Tral AdjustmentTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN/CAMBERTo Remove CABLES, Reverse Order Replacing BatteryTo Remove Wheel for Repairs To Start Engine with a Weak BAT- TeryTo Adjust Carburetor Fuel System BatteryOther Engine OILTroubleshooting Chart Problem Cause CorrectionExcessive Mower blades will Suggested Guide for Sighting Slopes for Safe Operation