Cleaning, Engine Cooling Fins See Fig, Muffler

MAINTENANCE

HANDLE

COVER

CARTRIDGE

PRE-CLEANER

BASETABS

SLOTS

FIG. 12

ENGINE COOLING FINS (See Fig. 13)

Remove any dust, dirt or oil from engine cooling ﬁns to prevent engine damage from overheating.

•Remove screws from blower housing and lift housing and dipstick tube assembly off engine.

•Cover oil ﬁll opening to prevent entry of dirt.

•Use compressed air or stiff bristle brush to thoroughly clean engine cooling ﬁns.

•To reassemble, reverse above procedure.

BLOWER HOUSING

SCREWSSCREWS

AIR SCREEN

DIPSTICK TUBE

ASSEMBLY

OIL FILL

OPENING

ENGINE COOLING FINS	SPARK
	PLUG

FIG. 13

MUFFLER

Inspect and replace corroded mufﬂer and spark arrester (if equipped) as it could create a ﬁre hazard and/or dam- age.

SPARK PLUGS

Replace spark plugs at the beginning of each mowing sea- son or after every 100 hours of use, whichever comes ﬁrst. Spark plug type and gap setting is shown in "PRODUCT SPECIFICATIONS" section of this manual.

IN-LINE FUEL FILTER (See Fig. 14)

The fuel ﬁlter should be replaced once each season. If fuel ﬁlter becomes clogged, obstructing fuel ﬂow to carburetor, replacement is required.

•With engine cool, remove ﬁlter and plug fuel line sec- tions.

•Place new fuel ﬁlter in position in fuel line with arrow pointing towards carburetor.

•Be sure there are no fuel line leaks and clamps are properly positioned.

•Immediately wipe up any spilled gasoline.

CLAMPCLAMP

FUEL

FILTER

FIG. 14

CLEANING

•Clean engine, battery, seat, ﬁnish, etc. of all foreign matter.

•Keep ﬁnished surfaces and wheels free of all gasoline, oil, etc.

•Protect painted surfaces with automotive type wax.

We do not recommend using a garden hose or pressure washer to clean your tractor unless the engine and trans- mission are covered to keep water out. Water in engine or transmission will shorten the useful life of your tractor. Use compressed air or a leaf blower to remove grass, leaves and trash from tractor and mower.