Poulan 179416 manual Storage, Other, Tractor, Battery, Fuel System, Engine Oil, Cylinders

Page 24
STORAGE

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

CAUTION: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

Clean entire tractor (See “CLEANING” in the Customer Responsibilities section of this manual).

Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

Lubricate as shown in the Customer Responsibilities section of this manual.

Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be discon- nected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Customer Respon- sibilities section of this manual).

After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL

H O S E , O R T A N K D U R I N G S T O R A G E . A L S O , EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

Drain the fuel tank.

Start the engine and let it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during stor- age. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not drain the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Customer Responsibilities section of this manual).

CYLINDER(S)

Remove spark plug(s).

Pour one ounce of oil through spark plug hole(s) into cylinder(s).

Turn ignition key to “START” position for a few seconds to distribute oil.

Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

24

Image 24
Contents MODEL NO. PO14542D 14.5 HP 42 Inch Lawn Tractor 179416 4.20.01 TR PRINTED IN U.S.ASAFETY RULES IV. SERVICEI. GENERAL OPERATION II. SLOPE OPERATIONTABLE OF CONTENTS SAFETY RULESSafe Operation Practices for Ride-On Mowers 25-26PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIESUNASSEMBLED PARTS Steering WheelSeat KeysASSEMBLY TOOLS REQUIRED FOR ASSEMBLYTO REMOVE TRACTOR FROM CAR- TON BEFORE REMOVING TRACTOR FROM SKIDHOW TO SET UP YOUR TRACTOR CHECK BATTERY See FigINSTALL SEAT See Fig CHECKLIST CHECK TIRE PRESSURECHECK DECK LEVELNESS CHECK FOR PROPER POSITION OF ALL BELTSOPERATION KNOW YOUR TRACTOR HOW TO USE YOUR TRACTOR TO ADJUST MOWER CUTTING HEIGHT See FigTO SET PARKING BRAKE See Fig STOPPING See FigBEFORE STARTING THE ENGINE TO ADJUST GAUGE WHEELS See FigTO OPERATE MOWER See Fig TO OPERATE ON HILLSMOWING TIPS ADD GASOLINETO START ENGINE See Fig CUSTOMER RESPONSIBILITIES GENERAL RECOMMENDATIONSLUBRICATION CHART BEFORE EACH USETRACTOR BRAKE OPERATIONTIRES OPERATOR PRESENCE SYSTEMENGINE BATTERYV-BELTS TRANSAXLE COOLINGCLEAN AIR SCREEN ENGINE COOLING FINS See FigAIR FILTER See Fig CLEANING MUFFLERSPARK PLUGS IN-LINE FUEL FILTER See FigSERVICE AND ADJUSTMENTS TO INSTALL MOWER See FigCAUTION BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS TO REMOVE MOWER See FigTO LEVEL MOWER HOUSING TO REPLACE MOWER BLADE DRIVE BELT See FigBOTH FRONT LINKS MUST BE EQUAL IN LENGTH TO ADJUST BRAKE See Fig TO ADJUST STEERING WHEEL ALIGNMENTTO START ENGINE WITH A WEAK BATTERY See Fig TO REPLACE MOTION DRIVE BELT See FigREPLACING BATTERY See Figs. 26 and TO REMOVE HOOD AND GRILL ASSEMBLY See FigTO REPLACE HEADLIGHT BULB INTERLOCKS AND RELAYSTO ADJUST THROTTLE CONTROL CABLE See Fig TO ADJUST CARBURETORSTORAGE OTHERFUEL SYSTEM ENGINE OILTROUBLESHOOTING POINTS PROBLEMCAUSE CORRECTIONEngine continues to run TRACTOR - - MODEL NUMBER PO14542D SCHEMATICREPAIR PARTS ELECTRICAL2122 PART DESCRIPTIONCHASSIS AND ENCLOSURES REPAIR PARTS DRIVE 202154407 Bellcrank Clutch178394 STEERING ASSEMBLY 68678546 KEY PART NO. NO. DESCRIPTION OPTIONAL EQUIPMENT Spark Arrester ENGINEREPAIR PARTS SEAT ASSEMBLY DECALS WHEELS & TIRES179128 179416MOWER LIFT REPAIR PARTS MOWER DECK 179292 179293SERVICE NOTES LIMITED WARRANTY SERVICE WARRANTYPOLICY SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION