Poulan PP3516AVX, PP4218AVX Other, Load Adjustment Engine, Empty fuel tank and refill with

Page 18

HELPFUL TIP

During storage of your gas/ oil mixture, the oil will sepa- rate from the gas.

We recommend that you shake the gas can weekly to insure proper blending of the gas and oil.

ENGINE

SRemove spark plug and pour 1 teaspoon of 40:1, 2-cycle engine oil (air cooled) through the spark plug opening. Slowly pull the starter rope 8 to 10 times to distrib- ute oil.

SReplace spark plug with new one of rec- ommended type and heat range.

SClean air filter.

SCheck entire unit for loose screws, nuts,

and bolts. Replace any damaged, broken, or worn parts.

SAt the beginning of the next season, use only fresh fuel having the proper gasoline to oil ratio.

OTHER

SDo not store gasoline from one season to

another.

S Replace your gasoline can if it starts to rust.

TROUBLESHOOTING TABLE

WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit.

TROUBLE

CAUSE

REMEDY

 

 

 

 

 

Engine will not

1. Ignition switch off.

1.

Move ignition switch to ON.

start or will run

2. Engine flooded.

2.

See “Difficult Starting” in

only a few

 

 

 

Operation Section.

seconds after

3. Fuel tank empty.

3.

Fill tank with correct fuel mixture.

starting.

4. Spark plug not firing.

4.

Install new spark plug.

 

5. Fuel not reaching

5.

Check for dirty fuel filter; replace.

 

 

carburetor.

 

Check for kinked or split fuel line;

 

 

 

 

repair or replace.

 

 

 

 

 

Engine will

1.

Idle speed requires

1. See “Carburetor Adjustment” in the

not idle

 

adjustment.

 

Service and Adjustments Section.

properly.

2.

Carburetor requires

2. Contact an authorized service dealer.

 

 

adjustment.

 

 

 

Engine will not

1.

Air filter dirty.

1. Clean or replace air filter.

accelerate,

2.

Spark plug fouled.

2. Clean or replace plug and regap.

lacks power,

3.

Chain brake engaged.

3. Disengage chain brake.

or dies under

4.

Carburetor requires

4. Contact an authorized service dealer.

a load.

 

adjustment.

 

 

 

 

 

 

 

 

 

Engine

1.

Too much oil mixed with

1.

Empty fuel tank and refill with

smokes

 

gasoline.

 

correct fuel mixture.

excessively.

 

 

 

 

 

Chain moves

1. Idle speed requires

1. See “Carburetor Adjustment” in the

at idle speed.

 

adjustment.

 

Service and Adjustments Section.

 

2. Clutch requires repair.

2.

Contact an authorized service dealer.

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Manual de Instrucciones Manuel d’Instructions 545137248 11/30/06Starting Reminder Using the chain sawAlways use two hands when operating the chain saw Chain TensioningMaintain Your SAW in Good Working Order Plan AheadOperate Your SAW Safely Handle Fuel with CautionKickback Reduce the Chance of KickbackMaintain Control Kickback Safety Features Chain Brake and CKA AngleComputed kickback angle CKA Table Assembly LoosenCutters Tighten Adjusting the tensionChecking the tension Use a screwdriver to move chain around guide barOperation Important Points to Remember Before Starting Engine Fueling EngineBAR and Chain Lubrication Cation Always stop the engine before removing the oil capBraking function control Caution The chain brake must be Starting a Warm EngineDifficult Starting or starting a flooded engine Inertia activating function controlFelling Large Trees Operating TipsTree Felling Techniques Notch CUT and Felling the TreeImportant Points Bucking Using a LOG or Support StandCutting a Fallen Tree Types of Cutting Used for BuckingPruning Limbing and Pruning Important PointsLimbing ING Without a SupportService Cleaning the Spark ARREST- ING Screen Inspect and Clean Unit and DecalsClean AIR Filter Check Fuel Mixture LevelStorage Other Load Adjustment EngineEngine Empty fuel tank and refill withLimited Warranty Ligations The U.S. Environmental
Top Page Image Contents