Poulan 545047542 instruction manual Troubleshooting Table, Need ASSISTANCE?, Need Service PART?

Page 16

Store unit with all guards in place. Position so that any sharp object cannot accidentally cause injury to passersby. Store the unit out of reach of children.

SBefore storing, drain all fuel from the unit. Start engine and allow to run until it stops.

SClean the unit before storing. Pay particu-

lar attention to the air intake area, keeping it free of debris. Use a mild detergent and sponge to clean the plastic surfaces.

SDo not store the unit or fuel in a closed area where fuel vapors can reach sparks or an open flame from hot water heaters, electric

motors or switches, furnaces, etc.

SStore in a dry area out of the reach of chil- dren.

TROUBLESHOOTING TABLE

CAUTION: It is important to prevent gum de- posits from forming in essential fuel system parts such as the carburetor, fuel filter, fuel hose, or fuel tank during storage. Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to fuel mixture separation and formation of acids during storage. Acidic gas can damage the engine.

NEED ASSISTANCE?

NEED ASSISTANCE?

Call 1--800--554--6723.

NEED SERVICE PART?

Contact your authorized service dealer.

WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit.

 

TROUBLE

CAUSE

REMEDY

 

 

 

 

 

Engine will not

1. Ignition switch off.

1. Move ignition switch to ON.

 

start or will run

2. Engine flooded.

2. See “Difficult Starting” in

 

only a few

 

 

 

Operation Section.

 

seconds after

3. Fuel tank empty.

3. Fill tank with correct fuel mixture.

 

starting.

4. Spark plug not firing.

4. Install new spark plug.

 

 

5. Fuel not reaching

5. Check for dirty fuel filter; replace.

 

 

 

carburetor.

 

Check for kinked or split fuel line;

 

 

 

 

 

repair or replace.

 

 

 

 

 

 

Engine will

1.

Carburetor requires

1. See “Carburetor Adjustment” in the

 

not idle

 

adjustment.

 

Service and Adjustments Section.

 

properly.

2.

Crankshaft seals worn.

2. Contact an authorized service dealer.

 

 

 

 

 

 

 

Engine will not

1.

Air filter dirty.

1.

Clean or replace air filter.

 

accelerate,

2.

Spark plug fouled.

2.

Clean or replace plug and regap.

 

lacks power,

3.

Chain brake engaged.

3.

Disengage chain brake.

 

or dies under

4.

Carburetor requires

4.

Contact an authorized service dealer.

 

a load.

 

adjustment.

 

 

 

 

 

 

 

Engine

1. Too much oil mixed with

1. Empty fuel tank and refill with

 

smokes

 

gasoline.

 

correct fuel mixture.

 

excessively.

 

 

 

 

 

Chain moves

1. Idle speed requires

1. See “Carburetor Adjustment” in the

 

at idle speed.

 

adjustment.

 

Service and Adjustments Section.

 

 

2. Clutch requires repair.

2.

Contact an authorized service dealer.

16

Image 16
Contents PP4620AVL Starting Reminder Plan AheadOperate Your SAW Safely Maintain Your SAW in Good Working OrderHandle Fuel with Caution KickbackMaintain Control Reduce the Chance of KickbackDo not cut more than one log at a time Elbow locked Thumb on underside of handlebarKickback Safety Features Chain Brake and CKA AngleComputed kickback angle CKA Table AssemblyAttaching the BAR & Chain If not Adjusting the tension Checking the tensionOperation Fueling & Lubrication StartingFueling Engine BAR and Chain LubricationCutting Methods Starting a Warm EngineChain Brake Important PointsTree Felling Techniques Felling Large TreesNotch CUT and Felling the Tree VanceBucking Using a LOG or Support Stand Cutting a Fallen TreeTypes of Cutting Used for Bucking Bucking Without a SupportLimbing and Pruning Important Points LimbingPruning ErlyService Cleaning the air filterCleaning the Spark Arresting Screen AIR FilterStorage Troubleshooting Table Need Service PART?Need ASSISTANCE? Trouble Cause RemedyLigations The U. S. Environmental Limited WarrantyElectrolux Home PRODUCTS, INC NANCE, Replacement and Repair of Emission Related Parts Any