Poulan 178085 owner manual Off

Page 26

TROUBLESHOOTING POINTS

PROBLEM

CAUSE

CORRECTION

 

 

 

 

 

Engine continues to run

1.

Faulty operator-safety presence control system.

1.

Check wiring, switches and connections. If not

when operator leaves seat

 

 

 

corrected, contact an authorized service center/

with attachment clutch

 

 

 

department.

engaged

 

 

 

 

 

 

 

 

 

Poor cut - uneven

1.

Worn, bent or loose blade.

1.

Replace blade. Tighten blade bolt.

 

2.

Mower deck not level.

2.

Level mower deck.

 

3.

Buildup of grass, leaves, and trash under mower.

3.

Clean underside of mower housing.

 

4.

Bent blade mandrel.

4.

Replace blade mandrel.

 

5.

Clogged mower deck vent holes from buildup of

5.

Clean around mandrels to open vent holes.

 

 

grass, leaves, and trash around mandrels.

 

 

 

 

 

 

 

Mower blades will not

1.

Obstruction in clutch mechanism.

1.

Remove obstruction.

rotate

2.

Worn/damaged mower drive belt.

2.

Replace mower drive belt.

 

3.

Frozen idler pulley.

3.

Replace idler pulley.

 

4.

Frozen blade mandrel.

4.

Replace blade mandrel.

 

 

 

 

 

Poor grass discharge

1.

Engine speed too slow.

1.

Place throttle control in “FAST” position.

 

2.

Travel speed too fast.

2.

Shift to slower speed.

 

3.

Wet grass.

3.

Allow grass to dry before mowing.

 

4.

Mower deck not level.

4.

Level mower deck.

 

5.

Low/uneven tire air pressure.

5.

Check tires for proper air pressure.

 

6.

Worn, bent or loose blade.

6.

Replace/sharpen blade. Tighten blade bolt.

 

7.

Buildup of grass, leaves and trash under mower.

7.

Clean underside of mower housing.

 

8.

Mower drive belt worn.

8.

Replace mower drive belt.

 

9.

Blades improperly installed.

9.

Reinstall blades sharp edge down.

 

10.

Improper blades used.

10.

Replace with blades listed in this manual.

 

11.

Clogged mower deck vent holes from buildup of

11.

Clean around mandrels to open vent holes.

 

 

grass, leaves, and trash around mandrels.

 

 

 

 

 

 

 

Headlight(s) not working

1.

Switch is “OFF”.

1.

Turn switch “ON”.

(if so equipped)

2.

Bulb(s) burned out.

2.

Replace bulb(s).

 

3.

Faulty light switch.

3.

Check/replace light switch.

 

4.

Loose or damaged wiring.

4.

Check wiring and connections.

 

5.

Blown fuse.

5.

Replace fuse.

 

 

 

 

 

Battery will not charge

1.

Bad battery cell(s).

1.

Replace battery.

 

2.

Poor cable connections.

2.

Check/clean all connections.

 

3.

Faulty regulator (if so equipped).

3.

Replace regulator.

 

4.

Faulty alternator.

4.

Replace alternator.

 

 

 

 

 

Engine “backfires”

1.

Engine throttle control not set at “SLOW”

1.

Move throttle control to “SLOW” position and allow

when turning engine

 

position for 30 seconds before stopping engine.

 

to idle for 30 seconds before stopping engine.

“OFF”

 

 

 

 

 

 

 

 

 

 

 

 

 

 

26

Page 25 Page 27
Image 26
Page 25 Page 27
Contents PR1742STC Safety Rules Safe Operation Practices for Ride-On MowersTable of Contents Product Specifications Customer ResponsibilitiesContents of Hardware Pack To Remove Tractor from Carton Tools Required for AssemblyHOW to SET UP Your Tractor Before Removing Tractor from SkidInstall Seat See Fig Check Tire Pressure To SET UP Your Mower for MulchingTo Convert to Bagging or Discharging Check Deck LevelnessEngine on Engine OFF OIL Pressure Lights on Battery Reverse Forward FastSee Safety Rules Section LightKnow Your Tractor HOW to USE Your Tractor Towing Carts and Other Attachments Before Starting the EngineTo Transport ADD GasolineMulching Mowing Tips Mowing TipsTo Start Engine See Fig Before Each USE Lubrication ChartGeneral Recommendations Tractor Belts Clean AIR ScreenEngine Transaxle CoolingSpark Plugs CleaningMuffler Engine OIL FilterTo Install Mower See Fig To Remove Mower See FigTo Level Mower Housing FRONT-TO-BACK Adjustment See FigsTo Replace Mower Blade Drive Belt See Fig To Adjust Brake See FigBelt Installation To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Transaxle Gear Shift Lever Neutral Adjustment See FigTo Adjust Steering Wheel Alignment Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb Replacing Battery See FigsTo Remove Hood and Grill Assembly See Fig Interlocks and RelaysTo Adjust Throttle Control Cable See Fig To Adjust CarburetorEngine OIL OtherFuel System CylindersTroubleshooting Points OFF Schematic Tractor - Model Number PR1742STCElectrical 2122KEY Part NO. NO.DESCRIPTION Chassis and Enclosures 174619 176554Drive 72140608 175410175765 73900600Steering Assembly 175146 175121177876 175118Seat Assembly 174894178085 DecalsWheels and Tires 178086Engine 170551 Control Th/ch Flag Mower Deck 174493 Tractor Model Number PR1742STC Mower Lift159460 Wire Asm Inner/Sprg W/plunger LT Page Limited Warranty Policy Suggested Guide for Sighting Slopes for Safe Operation Sighting GuideParts and Service

178085 specifications

The Poulan 178085 is a highly regarded chainsaw known for its durability, efficiency, and ease of use. Designed primarily for homeowners and light-duty commercial use, this model stands out for its impressive balance between power and user-friendliness. Whether tackling tree trimming, firewood cutting, or general yard maintenance, the Poulan 178085 delivers reliable performance.

One of the key features of the Poulan 178085 is its robust engine. Equipped with a 40cc gas-powered engine, this chainsaw generates enough power to handle various cutting tasks with ease. The engine is designed to be fuel-efficient, allowing users to maximize runtime while minimizing fuel consumption and emissions. Additionally, its easy-start technology ensures that the chainsaw can be fired up with minimal effort, making it accessible even for those who may be new to using chainsaws.

The chainsaw boasts a 16-inch bar, which provides an optimal cutting length for most home and garden applications. This ideal size strikes a balance between maneuverability and cutting capability, allowing users to cut through branches and logs efficiently. The low-kickback design of the bar and chain improves safety during operation, making it less likely for the saw to kick back unexpectedly.

Another notable characteristic of the Poulan 178085 is its lightweight construction. Weighing in at only about 10 pounds, this chainsaw is easy to handle and reduces user fatigue during extended periods of use. Its comfortable grip and well-placed controls enhance the overall user experience, allowing for smoother operation and better precision while cutting.

To further enhance safety, the Poulan 178085 includes a chain brake feature that stops the chain in the event of kickback. This critical safety mechanism is a vital addition for both novice and experienced users, providing peace of mind while operating the saw.

In terms of maintenance, the Poulan 178085 features an automatic oiling system that keeps the chain lubricated during cutting, ensuring a longer lifespan for both the chain and bar. This feature reduces the need for manual lubrication, making it more convenient for users.

In summary, the Poulan 178085 is a versatile and reliable chainsaw equipped with a powerful engine, a well-designed bar, and a range of safety features. Its lightweight design and user-friendly technologies make it an excellent choice for anyone looking to manage their yard work effectively and safely. Whether you are a seasoned professional or a DIY enthusiast, the Poulan 178085 is a tool that meets the demands of modern cutting and trimming tasks.
Top Page Image Contents