Infinity OVTR 2, OVTR 3 owner manual Installing the Feet, Foot Hole

IMPORTANT!

Figure 1. This bottom view shows the four locations of the foot holes and the ac cord channel on a Compositions Overture OVTR 2 or OVTR 3 speaker.

NOTE: Do not unfasten any screws. There are no user-serviceable parts inside the speaker. For service, please contact an authorized Infinity technician for help (also see “Troubleshooting” on page 8 and “Limited Five-Year Warranty” on page 12).

INSTALLING THE FEET

Compositions Overture OVTR 2 and OVTR 3 speakers use dual-purpose feet with spike and round ends for carpeted or hard-surface floors. Refer to Figures 1 and 2 as you perform the following steps:

1.Lay each speaker on its side and locate the four threaded holes on the bottom (see Figure 1).

For safety reasons, each speaker base contains a cord channel designed to keep the ac power cord away from the feet. During shipping, the cord may become dislodged from its intended position and upon subsequent speaker placement may be accidentally pierced by spiked feet. Please make sure that the 120 Vac power cord is inside the cord channel (see Figure 1).

Foot Hole	F U S E	Foot Hole
	S U F
	E
	Fuse Holder

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

	AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
	CAUTION:	ATTENTION:
~120V 60Hz	FOR CONTINUED PROTECTION AGAINST	UTILSER UN FUSIBLE DE
	RISK OF FIRE, REPLACE ONLY WITH SAME	RECHANGE DE MEME
300W MAX	TYPE OF FUSE: 2AG SB 250V	TYPE ET CALIBRE

OVTR 2 or
OVTR 3	Speaker
(bottom view)	Port
	Cord Channel
Foot Hole	Foot Hole

120 Vac Power Cord

2 ◆ Compositions Overture OVTR 2/OVTR 3 – Owner’s Manual