Operating the System

Figure 5. Wiring diagram shows polarity connections for one channel of a stereo or home theater system.

Receiver or

Amplifier

(rear view)

–

OVTR 2

OVTR 3

(rear view)

blk – + red

(one channel shown)

IMPORTANT!

Figure 6. Located on the OVTR 2 and OVTR 3 front is a BASS level control and a dual-color “Power On” LED.

Each Compositions Overture OVTR 2 or OVTR 3 speaker system contains a built-in power amplifier that drives the subwoofers and only requires connection of the ac power cord. For your convenience, the system is not fitted with a power on/off switch. Instead, an auto-sense circuit will instantly switch the system on when an audio signal is present, and will automatically revert to standby (drawing only 7 watts) when audio is absent for a minimum of 10 minutes. A dual-color “Power On” LED (see Figure 6 below) glows red when the amplifier is the stand- by mode and green when the amplifier is on.

If on/off switching is desired, connect the OVTR 2 ’s (or OVTR 3) ac power cord to an ac switched outlet. If you plan to leave for an extended period of time (e.g., vacation), switch the system off (or unplug the ac power cord).

This product is designed for (USA) 120 Vac use only. Do not connect it to any other line voltages.

OVTR 2

OVTR 3

(front view)

More	3	7	Less
Bass	4	6	Bass
		BASS

BASS CONTROL

OVTR 2

OVTR 3

(top view)

Power On	Stand-By
is green	is red

“POWER ON” LED

OVTR 2

OVTR 3

(front view)

6 ◆ Compositions Overture OVTR 2/OVTR 3 – Owner’s Manual