UNIT/MAINTENANCE Safety

SAvoid dangerous situations. Do not use in presence of flammable liquids or gases to avoid creating a fire or explosion and/or

causing damage to unit.

SAvoid dangerous environments. Do not use

in unventilated areas or where dust or ex- plosive vapors can build up.

STo reduce the risk of electric shock, the unit may have a polarized plug (one blade is wider than the other); if so, it will require the use of a polarized extension cord. The ap- pliance plug will fit into a polarized exten- sion cord only one way. If the plug does not fit fully into the extension cord, reverse the plug. If the plug still does not fit, obtain a correct polarized extension cord. A polar- ized extension cord will require the use of a polarized wall outlet. This plug will fit into the polarized wall outlet only one way. If plug does not fit fully into the wall outlet, re- verse the plug. If it still does not fit, contact a qualified electrician to install the proper wall outlet. Do not change the equipment plug,

extension cord receptacle, or extension cord plug in any way.

STo reduce risk of electrical shock, use exten- sion cords specifically marked as suitable for outdoor appliances having electrical rating not less than the rating of unit. Cord must be marked with suffix “W--A” (in Canada “W”). Make sure your extension cord is in good condition. Inspect extension cord before use and replace if damaged. Do not use a dam- aged cord. Cord insulation must be intact with no cracks or deterioration. Plug connectors must be undamaged. The extension cord used to reach the power source must be heavy enough to carry current from the power source the full length of the extension cord to the unit. An undersized extension cord will cause a drop in line voltage resulting in loss of power and overheating. If in doubt, use the next heavier gauge. The lower the gauge number, the heavier the cord.

SDo not use multiple cords.

SDo not abuse cord. Never carry the unit by the extension cord or yank extension cord to disconnect unit. To unplug, grasp the plug, not the cord. Do not use cord as a han- dle, close a door on cord, or pull cord around sharp edges or corners. Do not ex-

pose cords to heat, oil, or water.

SKeep the extension cord clear of operator and

obstacles at all times.

STie cord to cord retainer and connect to re- cessed plug as shown in this manual to pre- vent damage to unit and/or extension cord and to reduce the possibility of the exten-

sion cord disconnecting from the unit during operation.

SDo not attempt to repair unit. Inspect the insu- lation and connectors on the unit and exten- sion cord before each use. If there is any damage, do not use until damage is repaired

by your authorized service dealer.

SDo not use the unit if the switch does not turn the unit on and off properly. Have the unit repaired by your authorized service dealer.

SDo not use with damaged cord or plug. If unit is not working as it should, has been dropped, damaged, left outdoors, or

dropped into water, return it to your autho- rized service dealer for repair.

SAvoid unintentional starting of the unit. Nev- er carry unit with your finger on the switch. Be sure the switch is in the off position and never touch the switch when connecting extension cord.

SUnplug the unit from the power source when not in use, before servicing, and when chang-

ing accessories and/or attachments.

SAvoid any body contact with any grounded

conductor, such as metal fences, or pipes, to avoid the possibility of electric shock.

S Ground Fault Circuit Interrupter (GFCI) protection should be provided on the circuit or outlet to be used for the unit. Receptacles are available having built-in GFCI protec- tion and may be used for this measure of safety.

WARNING: Always stop unit and dis- connect spark plug wire (or disconnect unit from power source) before performing mainte- nance.

SInspect entire unit before each use. Replace damaged parts. Check for fuel leaks. Make sure all fasteners are in place and securely

fastened.

SMaintain unit according to recommended pro-

cedures.

SUse only recommended Poulan PRO parts

and accessories.

SBe sure chain stops moving when engine

idles (see CARBURETOR ADJUST- MENTS section of original manual).

SKeep others away when making carburetor

adjustments.

SNever start the unit with the clutch housing re-

moved. The clutch can fly off and cause seri- ous injury.

SKeep the handles driy, clean, and free of oil or fuel mixture.

SKeep fuel and oil caps, screws, and fasteners securely tightened.

SHave all maintenance and service not ex- plained in this manual performed by an autho- rized service dealer.

OPERATE YOUR PRUNER SAFELY

SOperate the pruner only in a well-ventilated outdoor area.

SDo not use a pruner to cut down trees or any

portion of the tree trunk.

S Only use for pruning limbs or branches overhead not greater than 6 inches (15 cm) in diameter.

SDo not cut small brush and saplings with the pruner. Slender matter may catch in the chain and be whipped toward you, pulling you off

balance.

SMake sure the chain will not make contact with any object while starting the engine. Never try to start the unit when the guide bar is in a cut.

115261226, 952711672, PP5500P specifications

The Poulan PP5500P is a powerful and versatile chainsaw designed for both professional and residential applications. This chainsaw is well-suited for cutting firewood, clearing trails, and performing various outdoor tasks. Its robust 50cc engine delivers reliable performance, ensuring that users can tackle substantial cutting jobs with ease.

One of the standout features of the PP5500P is its Easy Start technology, which simplifies the starting process significantly. This feature reduces the amount of effort needed to start the chainsaw, enabling users to get to work quickly without the frustration of traditional starting methods. It is particularly beneficial for those who might struggle with pull-start mechanisms.

The chainsaw comes equipped with a 20-inch bar and chain, providing an excellent cutting capacity for larger logs and branches. The long reach allows for efficient cutting without the need to reposition the saw frequently. This is ideal for tasks ranging from felling small trees to limbing and bucking.

Safety is another key consideration in the design of the Poulan PP5500P. It includes an automatic chain oiler that ensures the chain remains lubricated during use, reducing wear and tear and prolonging the life of both the chain and bar. Additionally, the chainsaw features a chain brake that activates in case of kickback, providing an added layer of safety for the user.

Ergonomics play a critical role in the overall experience of using the PP5500P. The chainsaw is designed with a comfortable handle that reduces user fatigue, even during extended periods of operation. The lightweight design, paired with balanced weight distribution, enhances maneuverability and control.

One of the notable characteristics of this chainsaw is its durability. Constructed with quality materials, the Poulan PP5500P is built to withstand the rigors of outdoor use. Its robust build ensures that the equipment remains functional even after long-term use, making it a reliable choice for users.

Overall, the Poulan PP5500P combines power, efficiency, and safety in a practical package, making it an ideal choice for anyone looking to handle serious cutting tasks. Its advanced features and user-friendly design make it a valuable addition to any toolkit, whether for professional landscapers or homeowners engaged in DIY projects.