Poulan CG46A, 964 04 06-07, 151673 owner manual Use Hardware - Group D

6	CONTAINER MOUNTING (See Fig. 6)
	No hardware required

1.Install one container to left side first with warning to outside of unit. Install another container to center posi- tion and one in right position.

NOTE: Right container should always overlap left container at center supports.

2.Close cover and lock latch handles over center support tubes.

COVER LATCH

HANDLES

CONTAINER

WARNING

CENTER
SUPPORT		3
TUBES		08
		02
	WAR	NING

7	LOWER CHUTE (See Fig. 7A & 7B)
	Use Hardware - - GROUP "D"

1.Press weld nut into rubber latch and install two latch hook assemblies to lower chute using screw, washer, and lock washer as shown.

2.Tighten hardware securely.

3.Raise and hold deflector shield in upright position.

4.Place rear of chute over rear of mower deck opening. Push chute down and forward to guide extended edge of chute between discharge guard and mower deck.

5.Hook front latch into tab hole on front of mower deck.

6.Hook rear latch into flange hole on back of mower deck.

CAUTION:Do not remove discharge guard from mower. Raise and hold guard when attaching lower chute and allow it to rest on chute while in operation.

LOCK WASHER

SCREW

02094

WAR NING

CONTAINER

HANDLECONTAINER WARNING

Fig. 6

WASHER

LATCH

WELD NUT

Fig. 7A

DEFLECTOR

SHIELD

FRONT

LATCH

REAR LATCH

Fig. 7B

9