and seek medical attention. An antivibration system does not guarantee the avoidance of these problems. Users who operate power tools
on a continual and regular basis must monitor closely their physical condition and the condition of this tool.
WHAT IS WHAT?
16
1
6
5
3
WHAT IS WHAT?
1.Throttle trigger
2.STOP switch
3.Primer button
4.Start lever
5.Fuel cap
6.Starter rope
7.Vacuum handle
8.Spark plug
9.Upper blower tube
12
14
15
2
8
9
10
4
7
10.Lower blower tube
11.
12.Elbow tube
13.Vacuum bag
14.Upper vacuum tube
15.Lower vacuum tube
16.Throttle position lever
17.Instruction manual
13
11
17
ASSEMBLY
CARTON CONTENTS
Check carton contents against the following list.
SBlower
SUpper blower tube S Lower blower tube S High velocity nozzle S Elbow tube
S Vacuum bag
S Upper vacuum tube S Lower vacuum tube
S Screw for vacuum tube assembly NOTE: It is normal for the fuel filter to rattle in the empty fuel tank.
ASSEMBLY
WARNING: Stop engine and be sure the impeller blades have stopped turning be- fore opening the vacuum inlet door or at- tempting to insert or remove the vacuum or blower tubes. The rotating blades can cause
serious injury. Always disconnect the spark plug before performing maintenance or ac- cessing movable parts.
WARNING: If received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure. Fol- low all safety information in the manual and on the unit.
DA standard screwdriver is required for as- sembly.
BLOWER ASSEMBLY
BLOWER TUBE ASSEMBLY
1.Align the rib on the upper blower tube with the groove in the blower outlet; slide the tube into place.
NOTE: The tube clamp bolt must be loose enough to allow blower tube to be inserted in blower outlet. Loosen the bolt by turning coun- terclockwise (do not remove nuts).