Blower Outlet
Rib
Groove
2.Secure the tube by turning the bolt clock- wise.
3.Align the slots on the lower blower tube with the tabs on the upper blower tube.
Upper Blower Tube
VACUUM ASSEMBLY
VACUUM BAG ASSEMBLY
1.Open the zipper on the vacuum bag and insert the elbow tube.
2.Push the small end of the elbow tube through the small opening in the bag.
Elbow
TubeRib
Zipper 
Opening
Small Opening NOTE: Make sure edge of the small open-
Tube clamp bolt and nut
Tab
Lower Blower Tube
Slot
ing is flush against the flared area of the el- bow tube, and the rib on the elbow tube is on the bottom.
3.Close the zipper on the bag. Make sure the zipper is closed completely.
4.Remove blower tubes from engine.
4.Slide the lower blower tube onto the upper blower tube.
5.Turn the lower blower tube clockwise until a click is felt to secure the lower blower tube to the upper blower tube.
NOTE: When the upper and lower blower tubes are assembled together properly, the arrows on both tubes will be aligned.
6.To remove the tubes, turn the bolt counter- clockwise to loosen the tubes (do not remove nuts); remove the tubes.
HIGH-SPEED NOZZLE ASSEMBLY
When greater air speed is desired, use the
1.Align the slots on the nozzle with the tabs on the lower blower tube.
Nozzle
Lower Blower | Tab Slot |
Tube |
2.Slide the nozzle onto the lower blower tube.
3.Turn the nozzle clockwise until a click is felt to secure the nozzle to the lower blow- er tube.
Rib
Groove
5.Insert the elbow tube into the blower outlet. Make sure elbow tube rib is aligned with the blower outlet groove.
6.Turn knob clockwise to secure elbow tube.
VACUUM TUBE ASSEMBLY
WARNING: Stop engine and be sure the impeller blades have stopped turning be- fore opening the vacuum inlet door or at- tempting to insert or remove the vacuum or blower tubes. The rotating blades can cause serious injury.
1.Insert the tip of a screwdriver into the latch area of the vacuum inlet.
Latch Area Blower
Outlet
Latch 
Area
Vacuum Inlet Cover
2.Gently tilt the handle of the screwdriver to- ward the front of the unit to release the latch while pulling up on the vacuum inlet cover with your other hand.