EN
SETUP SENSOR
1.Open the sensor battery compartment with a small Phillips screwdriver.
2.Insert the batteries, matching the polarity as shown in the battery compartment.
SWITCH | OPTION |
Channel | Channel 1 - 3. If you are using |
| more than one sensor, select a |
| different channel for each sensor. |
|
|
3.Set the channel. The switch is located in the battery compartment.
4.Place the sensor near the main unit. Press RESET on the sensor. Then, press and hold MEMORY and CHANNEL on the main unit to initiate signal sending between the sensor and the main unit. The reception icon on the main unit will blink for approximately 3 minutes while it is searching for the sensor. (Refer to the Data Transmission section for more information.)
5.Close the remote sensor battery compartment.
6.Secure the sensor in the desired location using the wall mount or table stand.
8
For best results:
•Insert the batteries and select the channel before you mount the sensor.
•Place the sensor out of direct sunlight and moisture.
•Do not place the sensor more than 98 feet (30 meters) from the main (indoor) unit.
•Position the sensor so that it faces the main (indoor) unit, minimizing obstructions such as doors, walls, and furniture.
•Place the sensor in a location with a clear view to the sky, away from metallic or electronic objects.
•Position the sensor close to the main unit during cold winter months as
You may need to experiment with various locations to get the best results.
Standard Alkaline batteries contain signifcant amounts of water. Because of this they will freeze in low temperatures of approximately 10° F. Disposable Lithium batteries have a much lower threshold for temperature with an estimated freezing range of below
8 | 05/1/18, 7:11 PM |