Oregon Scientific BAR388HG, 086L004438-013 user manual Sensor Data Transmission, Icon Description

3.Select a channel. Make sure you use a different channel for each sensor.

4.Place the sensor near the main unit. Press RESET on the sensor.

5.Simultaneously press CHANNEL and MEM on the main unit to initiate signal sending between the sensor and main unit.

6.Close the battery door and secure the screws.

7.Place the sensor in the desired location using the table stand or wall mount.

The transmission range may vary depending on many factors. You may need to experiment with various locations to get the best results.

Standard Alkaline batteries contain significant amounts of water. Because of this they will freeze in low temperatures of approximately -12°C (10°F). Disposable Lithium batteries have a much lower threshold for temperature with an estimated freezing range of below -30°C (-22°F).

Wireless ranges can be impacted by a variety of factors such as extremely cold temperatures. Extreme cold may temporarily reduce the effective range between the sensor and the base station. If the unit's performance fails due to low temperature, the unit will resume proper functioning as the temperature rises to within the normal temperature range (i.e. no permanent damage will occur to the unit due to low temperatures).

SENSOR DATA TRANSMISSION

The sensor reception icon in the remote sensor area shows the status.

ICON	DESCRIPTION
	Main unit is searching
	for the sensor(s)
	A channel has been found
	and sensor signal is being
	received
and “- - . -“	The sensor cannot be found.
(Outdoor	Search for the sensor or
temperature Area)	check batteries

EN

5