Scag Power Equipment GC-STT-CS manual Operate and test

Page 16

17.Install the weight support bar to the front of the machine by resting it directly on top of the caster support arms and sliding it tight against the frame of the machine. Secure the weight bar to the machine using (2) bar clamps, (4) 3/8-16 x 1-1/2" bolts and (4) 3/8-16 elastic stop nuts. See Figure 4-6.

18.Install the weight assemblies to the weight support bar and secure them to the bar using the 1/2"x 6-1/4" pin and lanyard. See Figure 5-5

WEIGHT (5x)

LANYARD

ELASTIC STOP PIN

NUT

BAR CLAMP

BOLT

WEIGHT SUPPORT BAR

2002 GC-STT Install Art 3-5

FIGURE 5-5

19. Operate and test.

14

Image 16

Contents OPERATOR’S Manual Remember Your Mower is only AS Safe AS the Operator Safety and Operating Instructions IntroductionDirection Reference Grass Catching OperationWhen dumping the hopper into a disposal area Assembly Instructions for 52 Cutter Decks Right Side Cutter Deck Shown Back Side Idler Pulley Blower Front Side Spindle Operate and test Assembly Instructions for 61 Cutter Decks Right Side Cutter Deck Shown Back Side Idler Pulley Blower Front Side Spindle Operate and test Assembly Instructions for 72 Cutter Decks Right Side Cutter Deck Shown Catcher Support Bracket Operate and test Hopper Assembly Grass Catcher Removal Instructions Clevis PINPage GC-STT Blower Housing Assembly Ref. Part No. Number Description GC-STT Blower Mounting Components Part Number Description GC-STT-CS Hopper Components 461627 Hopper, GC-STT-CS 482732 Door, GC-CS 461626 GC-STT Decals Limited WARRANTY- Commercial Accessory Scag Power Equipment