Grass Catcher Removal Instructions | Scag Power Equipment GC-STT-CS

6.1GRASS CATCHER REMOVAL INSTRUCTIONS

1.Prepare the work area making sure that it is a clean, safe environment.

2.Remove the rubber strap holding the adapter to the blower assembly. See Figure 5-1.

3.Remove the belt from the spindle pulley.

4.Remove the pin holding the blower assembly to the mounting bracket on the cutter deck and remove the blower assembly. See Figure 5-1.

		ADAPTER
BLOWER		MOUNTING
ASSEMBLY		MOUNTING
ASSEMBLY	PIN	BRACKET
	PIN	BRACKET

RIGHT SIDE OF

CUTTER DECK SHOWN

(Note: Some parts not shown for viewing purposes.)

GC-STC removal art 1

FIGURE 5-1

5.Remove the two (2) pins holding the hopper assembly to the mounting brackets on the rear of the machine. See Figure 5-2.

REMOVE

	HOOD OUT
ASSEMBLY
PULL

REMOVE

FIGURE 5-2

6.With the help of an assistant, remove the hopper assembly.

7.Remove the front weights by removing the quick pins.

8.Re-install the side discharge chute to the opening on the cutter deck. Replace the two (2) outside mounting bolts on the discharge chute with the clevis pins (p/n 04064-15) and rue cotter pins (p/n 04069-03). See Figure 5-3.

DISCHARGE	CLEVIS PIN
CHUTE	P/N 04064-15

CLEVIS PIN

P/N 04064-15RUE COTTER PIN P/N 04069-03

GC-STC removal art 3

FIGURE 5-3

WARNING

DO NOT OPERATE WITHOUT DISCHARGE CHUTE, MULCHING KIT, OR ENTIRE GRASS CATCHER INSTALLED