Hair Locking Bolts Pin | Scag Power Equipment GC-STWC-CS61V instruction

7.Install the blower assembly to the mounting bracket and secure with the mounting pin. See Figure 3-4.

8.Align the blower assembly with the discharge opening of the cutter deck. Tighten the hardware for the mounting bracket. See Figure 3-4.

9.Install the quick pin through the rear hole in the discharge chute mounting bracket. See Figure

3-4.

BLOWER

ASSEMBLY

QUICK

HAIR MOUNTING

PIN BRACKET

MOUNTING PIN

TIGHTEN MOUNTING

BRACKET HARDWARE

RIGHT SIDE OF

CUTTER DECK SHOWN

(Note: Some parts not shown for viewing purposes.)

2006 GC-STC-V install art 3

FIGURE 3-4

10.Install the belt to the spindle pulley. When replacing the belt, see figure below.

BACK SIDE

IDLER PULLEY BLOWER

PULLEY

12.Install the hopper mounting brackets to the outside of the frame on the rear of the machine. See Figure 3-5.

Hopper

Mounting

Brackets

Rear Frame

Figure 4 A GC-STT Install Art

FIGURE 3-5

13.With help from an assistant, install the hopper assembly to the machine by installing the mounting post into the hopper mounting brackets and secure with the ring pins. Tighten the bolts and jam nuts. See Figure 3-6.

	FRONT SIDE	SPINDLE
		PULLEY
	IDLER PULLEY

11.Install the new belt covers and secure. See items number 1 and number 21 on page 10 of the Blower Mounting Components section in the Illustrated Parts List for proper installation.

	Hair	Locking
	Hair	Bolts
	Pin	Bolts
	Pin
		Ring Pins
	Locking
	Bolts

Ring Pins

FIGURE 3-6