Scag Power Equipment SWZ manual Lubrication & Maintenance, Comments

LUBRICATION & MAINTENANCE

Break-In

(1st 10 Hours)

8 Hours (Daily)

40 Hours (Weekly)

100 Hours (Biweekly)

				200 Hours (Monthly)
					PROCEDURE	COMMENTS
X					Check all hardware for proper tightness
X					Change engine oil and filter at 5 hours
X					Check hydrostatic oil filter at 20 hours	Add oil as needed - SAE 10W30
X					Check belts for proper adjustment	Check after 2,4,8 hours of running
	X
					Check engine oil	Do not over fill
	X				Clean blower screen	MORE OFTEN IF NEEDED
	X				Remove debris from under belt cover	MORE OFTEN IF NEEDED
	X				Sharpen cutter blades	MORE OFTEN IF NEEDED
	X				Grease spindle bearings *	+ US Lithium MP White Grease 2125
	X				Clean air filter	MORE OFTEN IF NEEDED
		X
					Check battery acid level	Distilled water only
		X			Check tire pressure	Add or adjust as needed
			X
					Grease caster wheel bearings	Chassis grease
			X		Grease caster wheel pivots	Chassis grease
			X		Grease idler arm pivots	Chassis grease
			X		Change engine oil and filter	See engine manufacturer information
			X		Replace air filter	MORE OFTEN IF NEEDED

XCheck all hardware for proper tightness

X	Clean and adjust spark plugs	See engine mfg. information
X	Drain Hydraulic System and replace fluid	Use SAE 10W30 motor oil
X	Change hydrostatic oil filter	Clean area before removing filter

*Depending on climate and environment, lubrication may be required every 8 to 40 hours. Grease spindle until grease comes out the grease relief valve.

+Compatible Greases: US Lithium MP White Grease 2125 Mobilux #2 found at Mobil Service Stations Ronex MP found at Exxon Service Stations

Super Lube MEP #2 & Super Stay-M #2 found at Conoco Service Stations Shell Alvania #2 found at Shell Service Stations

Lidok EP #2 found at industrial shops

12