Sarlo BC-8 Shield Assembly Instructions, Shield Assembly for Brush Cutter Blade High Position

Page 6

SHIELD ASSEMBLY INSTRUCTIONS

WARNING!

IN ORDER FOR THE UNIT TO FUNCTION PROPERLY AND SAFELY THE DEBRIS SHIELD MUST BE ATTACHED TO THE GEAR BOX IN THE CORRECT POSITION. THE SHIELD CAN BE ATTACHED IN A HIGH POSITION OR A LOW POSITION.

WHEN USING THE BLADE THE SHIELD MUST BE IN THE HIGH POSITION.

WHEN USED AS A LINE TRIMMER THE SHIELD MUST BE IN THE LOW POSITION.

SHIELD ASSEMBLY FOR LINE TRIMMER (LOW POSITION)

THE BRACKET (FIG. 1) MUST BE MOUNTED TO THE SHIELD WITH THE OPEN SIDE UP AS SHOWN. SECURE THE BRACKET AND SHIELD TO THE GEAR BOX WITH THE 4 SCREWS INCLUDED. TIGHTEN THE SCREWS FIRMLY WITH A 4mm ALLEN WRENCH.

Fig. 1

SHIELD ASSEMBLY FOR BRUSH CUTTER BLADE (HIGH POSITION)

THE BRACKET (FIG. 2) MUST BE MOUNTED TO THE SHIELD WITH THE OPEN SIDE DOWN AS SHOWN. SECURE THE BRACKET AND SHIELD TO THE GEAR BOX WITH THE 4 SCREWS INCLUDED. THE TOP OF THE BRACKET MUST BE EVEN WITH THE TOP OF THE SHIELD. TIGHTEN THE SCREWS FIRMLY WITH A 4mm 4MM ALLEN WRENCH.

Fig. 2

4

Image 6
Contents Brush CUTTER/ Trimmer Model BC-8 Safety and International Symbols Symbol MeaningRules for Safe Operation Safety Rules Safety Rules Assembly Instructions Installing Cutting HeadShield Assembly Instructions Shield Assembly for Brush Cutter Blade High PositionUsing the Cutting Blade Operating InstructionsTips for Best Trimming Results Adjusting Trimming Line LengthHolding the Trimmer Decorative TrimmingMaintenance Periodic Maintenance ChartSERVICE/ADJUSTMENTS Line Replacement Safety RulesRefilling Trimming Line Blade Replacement Safety Rules Replacement ProcedurePart Sequence Troubleshooting Guide Check Probable Causes ActionFuel System StorageSeasonal Storage EngineEngine/Motor/Moteur Illustrated Parts List Warranty Products Consumer Use Commercial/Rental Use