OPERATION - All mowers
Adjusting the cut height (Continued)
The Rover lawnmower has ten height settings controlled by the height adjustment lever located at the rear right hand wheel.
Grasp the height adjustment lever (1) and pull the lever away from the base to disengage the lever from the height adjustment rack (2).
Move the lever either forwards or backwards to the desired position and release the lever so as to engage in the height adjustment rack
Installing the grass catcher– refer figures 5 and 6.
Figure 4.
Height adjustment
WARNING
The grass catcher should only be fitted or removed when the engine is stopped. Never raise the rear flap when the engine is running.
Raise the rear flap of the mower.
Grasp the grass catcher by the top handle and position the grass catcher against the rear of the mower. Refer to Figure 5.
Locate the grass catcher above the grass catcher support bracket. Align the catcher lugs with the hooks each side and lower the catcher into place. Refer to Figure 6.
Lower the rear flap so that the back edge of the rear flap hooks over the matching lip on the grass catcher.
Figure 5. Grass catcher fitment | Figure 6. Support bracket detail |
Removing the grass catcher– refer figure 7.
Raise the rear flap of the mower to release the grass catcher.
Lift the grass catcher clear of the mower and lower the rear flap.
Emptying the grass catcher - refer figure 7
Remove the grass catcher (as per the instructions above).
Tilt the grass catcher with the opening downwards.
Grip the large channel in the rear bottom of the grass catcher with the other hand and shake the clippings out. Refer to figure 7.
Figure 7.
Emptying grass
catcher
4