STORING FREQUENCIES INTO CHANNELS
1.When the scanner displays a fre- quency you want to store while scanning the banks or searching the search bands, press PROG. CH flashes, and HOLD and the fre- quency number appear.
2.Press PRIVATE, POLICE, or FIRE/ EMG to store the frequency into a channel. For example, if you want to store the frequency in one of the channels in the POLICE ser- vice search bank, press POLICE.
If the search bank you selected has an empty channel, the fre- quency number flashes alternately with the lowest empty channel number and 000.0000. If the search bank you selected has no empty channels, the frequency number flashes alternately with the channel number of the last channel where you stored a fre- quency.
Note: If you press a service search bank key other than PRI- VATE, POLICE, or FIRE/EMG, the scanner beeps several times and Error appears. If you are scan- ning the banks, press PRIVATE,
POLICE, or FIRE/EMG, then start again from Step 1. If you are searching the search bands,
press SEARCH then start again from Step 1.
3.Press PROG to store the fre- quency in the displayed channel. Or, repeatedly press s or t, select a channel number, then press PROG. The scanner displays the channel number where you stored the frequency.
Note: If you select a channel with a frequency already stored in it, the scanner replaces the fre- quency with the new one.
To cancel storing the frequency, press BAND.
4.Repeat Steps
5.When you finish storing frequen- cies, set MEMOLOCK OFF/ON to
ON to prevent accidentally chang- ing them (see “Using Memolock” on Page 23).
21