CLEARING FREQUENCIES FROM CHANNELS
You can clear a frequency from a channel by storing an empty frequen- cy in its place.
Notes:
•You cannot clear or change any of the frequencies in the scanner’s search bands, any of the scan- ner’s preset weather frequencies, or the preset frequencies in the service search banks.
•When you clear a channel, the scanner automatically locks out the channel (see “Locking Out Channels and Frequencies” on Page 23).
1.Be sure MEMOLOCK OFF/ON is set to OFF (see “Using Memolock” on Page 23).
2.Press SEARCH, then repeatedly press BAND to select a search band. SRCH and the search band range for each band appear.
3.Press HOLD when the scanner starts automatically searching that band. HOLD appears.
4.Press PROG. CH flashes.
5.Press s or t until 000.0000 appears.
6.Press PRIVATE, POLICE, or FIRE/ EMG to select the bank that con- tains the channel you want to clear.
HOLD and PRIVATE, POLICE, or FIRE/EMG appears, and a channel number flashes.
7.Repeatedly press s or t until the scanner displays the channel you want to clear. 000.0000 flashes alternately with the channel num- ber and the frequency number.
8.Press PROG to store the empty frequency. The channel number and 000.0000 appear.
To cancel clearing the channel, press BAND.
9.Repeat Steps
10.When you finish clearing chan- nels, set MEMOLOCK OFF/ON to
ON to prevent accidentally chang- ing them (see “Using Memolock” on Page 23).
22