HBZ2610
9. Maintenance
Maintenance, replacement, or repair of the emission control device and systems may be performed by any
■ MAINTENANCE CHART
|
|
| every | every | every |
|
|
|
| 25 | 50 | 100 |
|
system/compornent | procedure | before | hours | hours | hours | note |
|
| use | after | after | after |
|
fuel leaks, fuel spillage | wipe out | ✔ |
|
|
|
|
|
|
|
|
|
|
|
fuel tank, air filter, fuel filter | inspect/clean | ✔ | ✔ |
|
| replace, if necessary |
idle adjusting screw | see ■ADJUSTING | ✔ |
|
|
| replace carburetor |
IDLING SPEED (p.11) |
|
|
| if necessary | ||
|
|
|
|
| ||
spark plug | clean and readjust |
|
| ✔ |
| GAP: .025in(0.6~0.7mm) |
plug gap |
|
|
| replace, if necessary | ||
|
|
|
|
| ||
cylinder fins, intake air cooling vent | clean |
| ✔ |
|
|
|
|
|
|
|
|
|
|
muffler, spark arrester, cylinder exhaust port | clean |
|
| ✔ |
|
|
throttle trigger, stop switch | check operation | ✔ |
|
|
|
|
screws/nuts/bolts | tighten/replace | ✔ |
|
| ✔ | not adjusting screws |
|
|
|
|
|
|
|
F8
F9
WARNING
Make sure that the engine has stopped and is cool before performing any service to the blower. Contact with rotating blower fan or hot muffler may result in a personal injury.
■AIR CLEANER
•Check the air cleaner every 25 hours of use or more frequently if used under dusty conditions. A clogged air filter may increase fuel consumption while cutting down the engine power. Never operate the blower without the air filter or with a deformed filter element because unfiltered dusty air may quickly ruin the engine.
CLEANING AIR FILTER:
1.Remove the air cleaner cover.
2.Use neutral detergent and warm water to clean the filter element. After cleaning, air dry the element completely.
3.Reinstall the filter.
Never forget to attach the screen. If the screen is not attached, the cleaner will not seal properly and the dusts come into the cylinder.
(1)Element
(2)Screen
■FUEL FILTER
•A clogged fuel filter may cause poor acceleration of the engine. Check periodically to see if the filter is clogged
F10
F11
with dirt. The filter can be taken out of the fueling port using a small wire hook. Disconnect the filter assembly from the fuel pipe and unhook the retainer to disassemble it. Clean the components with gasoline.
(1)Screen
(2)Element
(3)Holder
(4)Retainer
■SPARK PLUG
•The spark plug may gather carbon deposits on its firing end with reasonable use. Remove and inspect the spark plug every 25 hours and clean the electrodes as necessary with a wire brush. The spark gap should be adjusted to .025 in (0.6~0.7mm).
•Plug manufacturers recommend replacing the plug twice a year to avoid unexpected plug failure in a job.
REPLACEMENT PLUG IS A NGK CMR7H.
IMPORTANT
•Note that using any spark plugs other than those designated may result in the engine failing to operate properly or in the engine becoming overheated and damaged.
•To install the spark plug, first turn the plug until it is finger tight, then tighten it a quarter turn more with a socket wrench.