RedMax HEZ2460S MA1 AIR Filter, Muffler, MA4, Spark Arrester, MA2, Fuel Filter, MA3, Spark Plug

Page 15

HEZ2460S/HEZ3060S

9. Maintenance

WARNING

Make sure that the engine has stopped and is cool before performing any service to the machine. Contact with moving cutting head or hot muffler may result in a personal injury.

MA1

AIR FILTER

• The air filter, if clogged, will reduce the

 

 

engine performance. Check and clean

 

the filter element. If the element is

MUFFLER

WARNING

• Inspect periodically, the muffler for

U

loose fasteners, any damage or

S

corrosion. If any sign of exhaust leakage is found, stop using the machine and have it repaired immediately.

Note that failing to do so may result in the engine catching on fire.

broken or clogged, replace with a new

one. (MA1)

(1) (1) air filter

MA4

SPARK ARRESTER

• The muffler is equipped with a spark

arrester to prevent red hot carbon from

flying out of the exhaust outlet.

Periodically inspect and clean as

necessary with a wire brush.

MA2

(1)

FUEL FILTER

When the engine runs short of fuel supply, check the fuel cap and the fuel filter for blockage. (MA2)

(1) fuel filter

(1)

In the State of California it is required

by law (Section 4442 of the California

Public Resources Code) to equip a

spark arrester when a gas powered tool

is used in any forest covered, brush

covered, or grass covered unimproved

land. (MA4)

MA3

.026 in

0.65 mm

[HEZ2460S]

.037 in

0.95 mm

[HEZ3060S]

SPARK PLUG

Starting failure and mis-firing are often caused by a fouled spark plug. Clean the spark plug and check that the plug gap is in the correct range. For a replacement plug, use the correct type specified by RedMax. (MA3)

HEZ2460S: NGK CMR7H

HEZ3060S: NGK CMR7H-10

IMPORTANT

Note that using any spark plug other than those designated may result in the engine failing to operate properly or in the engine becoming overheated and damaged.

To install the spark plug, first turn the plug until it is finger tight, then tighten it a quarter turn more with a socket wrench.

(1) spark arrester

GEAR CASE

• The reduction gears are lubricated by

MA5multipurpose, lithium-based grease in the gear case. At every 25 hours of use, supply the gear case with new grease. (MA5)

Remove the cutter holders before installing new grease to arrange for old grease to exit. (MA6)

NOTE

When removing and installing the holder(A), use care not to allow any dirt and dust entering in to the gear case. (MA6)

TIGHTENING TORQUE:

87~104 in-lbs

(9.8~11.8 N.m.)

US-15

Image 15
Contents HEZ2460S HEZ3060S Contents Parts location SpecificationsSymbols on the machine Emission ControlManufactured For safe operation Using the product Before useStarting the engine Storage Fuel safetyMaintenance TransportDisposal SE2 Set upMounting Other Parts SE1 Screw Clamp bolt Tightning Torque 70~130 in-lb 8~15 N.mGasoline Requirements WarrantyFuel FuelHOW to MIX Fuel Recommended Mixing Ratio Gasoline 50 OIL For Your Engine LIFE, AvoidFueling the Unit Operation Stopping Engine OP4 OP8 HOW to USEAdjusting Throttle Cable Adjusting Idling Speed OP7Maintenance Chart MaintenanceSpark Arrester MA1 AIR FilterMuffler MA4MA8 Procedures to be Performed After Every 100 Hours of USEMA6 Blade MA6 Intake AIR Cooling VentCase 1. Starting failure Troubleshooting guideStorage DisposalWhat is Covered Manufacturers Warranty CoverageOwners Warranty Responsibilities Warranty Commencement DateWhere to GET Warranty Service Emission Warranty Parts ListWhat is not Covered HOW to File a Claim

HEZ2460S, HEZ3060S specifications

The RedMax HEZ2460S and HEZ3060S are two powerful and efficient handheld blowers designed for professional use. RedMax, a brand known for its high-quality outdoor power equipment, has equipped these models with advanced features and technologies that enhance performance, durability, and user comfort.

The HEZ2460S and HEZ3060S are both powered by low-emission engines that comply with stringent environmental regulations. This ensures that users can operate these blowers with minimal impact on the environment while still benefiting from robust performance. The HEZ2460S features a 24.5cc engine, while the HEZ3060S is equipped with a more powerful 30.5cc engine, providing users with options depending on their specific power needs.

One of the standout characteristics of these models is their ergonomic design. The blowers are crafted to reduce operator fatigue, allowing for extended use without discomfort. This is particularly important for professionals who need to use these tools for long periods. The well-balanced structure ensures that weight is distributed evenly, and the adjustable shoulder straps further enhance user comfort.

Both models utilize RedMax's advanced airflow technology, which maximizes blowing efficiency. This technology allows users to move large volumes of debris with ease, making yard clean-up and maintenance quicker and more effective. The HEZ3060S, with its larger engine, is particularly adept at handling tougher tasks, such as clearing wet leaves or heavy debris.

Additionally, the HEZ2460S and HEZ3060S are equipped with a cruise control feature, enabling users to maintain a steady flow of air without continuous throttle input. This not only simplifies operation but also enhances fuel efficiency, allowing users to get more work done with less fuel consumption.

Maintenance is also made simpler with both models, which feature easy-access air filters and spark plugs. This reduces downtime and ensures that users can perform routine maintenance with minimal hassle, prolonging the life and performance of the equipment.

In summary, the RedMax HEZ2460S and HEZ3060S handheld blowers are high-performance tools that combine power, comfort, and efficiency. With low-emission engines, ergonomic designs, advanced airflow technology, and user-friendly features, they are ideal for professionals needing reliable equipment for yard maintenance and cleanup tasks. Their durability and ease of use make them a valuable addition to any landscape maintenance arsenal.