RedMax BT2200LDC, HE2200LDC, BC2200E Maintenance, Replacing Trimming Line, Winding NEW Line,  9 

MAINTENANCE

I. Bump head for BT2200LDC and BC2200E

■REPLACING TRIMMING LINE

To refill a new trimming line either ;

A : Install the prewound reel #153577 or

B : Rewind the existing reel.

For replacement line, use a diameter of .080 in (2.03 mm). The engine may overheat and fail if you use a larger line. For safety reason, do not use metal-reinforced line.

A : REWINDING THE EXISTING SPOOL

• DISASSEMBLING THE HEAD

1.Hold the outer spool with one hand and unscrew the Bump Knob bolt (counter- clockwise for BT2200LDC and BC2200E). Inspect the captured bolt inside the Bump Knob to make sure it moves freely. Replace the Bump Knob if it is damaged.

BT2200LDC

BC2200E

2.Remove the inner reel. Use a clean cloth to clean the inner reel, the inside of the outer spool and the center shaft.

3.Inspect the indexing teeth on the inner reel and outer spool for wear and, if necessary, deburr or replace the reel and spool.

• WINDING NEW LINE

1.Take 25 ft (7.6 m) of new trimming line, insert one end through either hole on the inner reel and put the other end through another hole. Hold the line where the both ends are matching and pull it to make the loop as small as possible.

2.Wind the line in the direction indicated on the inner reel, in even and tight layers. Be sure not to overlap the two ends of the line.

3.Insert each end of the line into the holding slot.

9 