and 1/3 of the
SECURING THE SPA COVER
The spa cover can be secured by snapping the latch- es on the spa cover into the buckles on the side pan- els.
If the level is too low, add half of one of the ÒQUICK pHix It UPÓ packets to the water. Let the water circu- late through the spa jet unit for five minutes. Test the pH level again. Repeat until the pH level is correct.
If the level is too high, add half of one of the ÒQUICK pHix It DOWNÓ packets to the water. Let the water cir- culate through the spa jet unit for five minutes. Test the pH level again. Repeat until the pH level is cor-
The buckles can be locked by inserting the key and turning it clockwise a quarter turn. To unlock the buckles, insert the key and turn it counter- clockwise a quarter turn.
Latch
Buckle
Key
rect.
Replace the spa cover and allow the water to contin- ue to heat.
See WATER CHEMISTRY on page 13 for information concerning proper water maintenance.
Always keep the buckles locked when the spa is not in use. Keep the keys in a safe place, out of the reach of children.
DIAGRAM OF THE CONSOLE
USING THE CONSOLE
Refer to the console diagram above. The function of each console control is explained below:
Primer: This opening allows you to prime the spa jet unit before operation (see PRIMING THE SPA JET UNIT on page 10).
Thermostat: Controls the temperature of the water. The water heats at about 1.7¡F an hour with the cover on. The thermostat can be set to heat the water from 70¡F to 104¡F. Use a medical or other accurate ther- mometer to check the temperature of the water.
On/Off: Turns the spa jet unit on and off. When you first press the on/off button, the spa jet unit will run at low speed, providing gentle hydrotherapy. Press the button again and the spa jet unit will run at high
speed, providing more intense hydrotherapy. Press the button a third time and the spa jet unit will shut off.
The spa jet unit also features an automatic mode, which heats and filters the water when the spa is left unattended. When the spa jet unit is first plugged in, or if the buttons on the console have not been used for longer than twenty minutes, the automatic mode will begin filtering or heating the water, as needed.
Note: to keep the filter and heat cycles from run- ning, the power cord must be unplugged.
Air Control: Determines the amount of air that is in the spa jet system during operation. If the control is turned to the left, the amount of air flowing through the jets will increase. If the control is turned to the right, the amount will decrease.
11