USING THE RESTORATION 600
The RESTORATION 600 is designed for up to four adults. The six water jets can be regulated to provide a relaxing massage to sooth away stress, and the strength of the water massage can be adjusted by the air control. The RESTORATION 600 holds 300 gal- lons of water and offers an automatic, programmable heating (70¡F to 104¡F) and filtration system.
The guidelines below explain how to properly use the RESTORATION 600. Follow these guidelines to main- tain the spa for your
PRIMING THE SPA JET UNIT
The water pump in the spa jet unit must be primed before you use the RESTORATION 600 the first time. You must also prime the pump before using the unit each time you
To prime the spa jet unit, remove the primer cap from the console. Fill the spa jet unit with at least 64 oz. of water. Replace
and tighten the primer cap. IMPOR- TANT: The spa jet
unit may be seriously damaged if the pump is not properly primed, or if the primer cap is not replaced and fully tightened.
PLUGGING IN THE RESTORATION 600
Once the RESTORATION 600 is filled with enough water to cover the water jets and the pump has been primed, the power cord can be plugged in and the spa jet unit can be turned on. Note: The first time the power cord is plugged in, the spa jet unit will turn on automatically.
Grounded circuit capable of carrying 15 or more amps
Test and Reset
Buttons
GFCI
When connecting the power cord, plug the power cord directly into a grounded circuit capable of carrying 15 or more amps. No other appliance should be on the same circuit. Replace the power cord immediately if it becomes damaged.
The power cord is equipped with a Ground Fault Circuit Interrupter (GFCI), located at the end of the power cord. You should always test the GFCI before using the RESTORATION 600.
First, turn on the RESTORATION 600 by pressing the power button on the console. Once the unit is run- ning, press the GFCI ÒtestÓ button. The RESTORA- TION 600 should shut off. Press the ÒresetÓ button. The RESTORATION 600 should resume normal oper- ation. If the RESTORATION 600 continues to run after the ÒtestÓ button is pressed, then the GFCI is dam- aged. Do not use the RESTORATION 600 until the GFCI has been repaired or replaced by a qualified electrician.
STARTING THE RESTORATION 600
Once you have tested the GFCI, you should verify the water flow from the pumping unit. Set the air control on the console to the lowest setting (see USING THE CONSOLE on the next page). The pumping unit will heat the water as it pumps. Cover the RESTORA- TION 600 with the spa cover. The spa cover must be tight. The water will heat at about 1.7¡F an hour with the cover on. If you are using the RESTORA- TION 600 indoors, and the room temperature is main- tained at 70¡F, it will take approximately 20 to 28 hours for the water to reach the set temperature.
The temperature and water flow can be set or changed by the controls on the console (see USING THE CONSOLE on the next page).
TESTING AND TREATING THE WATER
The RESTORATION 600 comes with a starter chemi- cal pack for maintaining the water in the spa. Disregard the directions on the individual packages of ÒQUICK pHix It DOWNÓ and ÒQUICK pHix It UP.Ó However, the directions on the bottle of
The first time you use the spa, you should test and treat the water. Once you have verified that the spa jet unit is functioning properly, and have allowed the water to circulate for a while, you should remove the spa cover and add 1/3 of the ÒBromine BaseÓ bottle,
10