How to activate or deactivate Auxiliary Functions

D4 Profoto D4 – Generators

the Power Display [10] from 1-32 by turning the Power Dial [13] for outlet D. At channels 16-32 it’s also possible to change the sub channels (“quads”) from “A”, “b”, “C” to “d” by pressing down the dial while rotating.

How to activate or deactivate Auxiliary

functions

Release the Auxiliary Functions Button [7] after setting the function(s). The Auxiliary Functions Display[8] will now show the chosen function and the generator works with this settings. If more than one auxiliary function is activated, the display shows intermittently all functions.

To turn off any of the auxiliary functions, simply hold down the Auxiliary Functions Button

[7]and push the Flash and Modelling Light Button(s) [12] at the corresponding outlet(s) – an “Off” in the display indicates that the regarding function is deactivated. If no auxiliary function is activated, the Auxiliary Functions Display [8] will indicate “- -”.

Memory Function

It is possible to save up to three combined power and auxiliary function settings in the D4’s memory. This makes it easier to repeat even the most complex set-ups. With the “Profoto Studio” software you can save an almost unlimited number of set-ups (see page 35-40).

PLEASE NOTE! When deactivating the D4 with the On/Standby Button [3], the generator automatically saves the last power (of all outlets) and auxiliary settings in memory A. The A position is used as “safety memory” and can’t be programmed individually. After reactivating the D4 by pushing the On/Standby Button [3], the generator automatically starts with these settings. To prevent mistakes, all auxiliary functions (except the radio channel) stored in this memory are deactivated if the generator was disconnected from the mains. If you want to use them, it is necessary to activate them again (see page 26).

Additionally it is possible to store three complete setups in memory B, C and D permanently.

How to save:

1.After setting the generator press and hold down the Ws/f-stop Switch and Memory Button [11], the Ready Lamp [18] goes off and a double beep signal confirms that you entered the memory mode.

2.While still holding down the Ws/f-stop Switch and Memory Button [11], you choose the memory position by pressing and holding down one Flash and Modelling Light On/Off Button [12] at outlet B, C or D.

Profoto D4 – Generators D4

3.Now you release the Ws/f-stop Switch and Memory Button [11] first, a beep confirms the setting and you can also release the Flash and Modelling Light On/Off Button [12] – the Ready Lamp [18] is lit again.

How to recall:

1.Press and hold down the Ws/f-stop Switch and Memory Button [11]. The Ready Lamp [18] goes off and a double beep signal confirms that you have entered the memory mode.

2.Quickly press the Flash and Modelling Light On/Off Button [12] of the desired memory once. It is possible to check the content of the three memories by pushing the different Flash and Modelling Light On/Off Buttons [12] at outlets B, C and D.

3.Release the Ws/f-stop Switch and Memory Button [11] a beep signal and the activated Ready Lamp [18] confirm the setting and the generator uses the functions stored in the selected memory.

Profoto

The Light Shaping Company

Profoto