OPERATING INSTRUCTIONS
GENERAL CONTROLS
Preset Electronic Equalizer
When the unit is switched "On" for the first time, the Equalizer will be in the "Flat" setting. Press the PRESET EQ buttonrepeatly to select "ROCK", "POP", "CLASSIC" or "JAZZ" sound effect to suit your taste. The appropriate EQ Indicator lights to confirm your selection.
Mute Button 
Remote Control Only
To temporarily shut off the sound from the speakers press the MUTE button on the remote control. The STANDBY/MUTE indicator on front panel will flash and the sound will stop. Press the MUTE button again to cancel Mute and restore the sound. The MUTE indicator goes "O ff".
Balance Control
This control adjusts the relative volume of the left and right speakers. When this control is set to the
FM Mono/Hi-Speed Dubbing ON 
/OFF 
Selector
This button is used to select between the FM STEREO and FM MONO operation
modes (It is also used to select either 
Normal Speed or 
High Speed tape dubbing.) To receive FM Stereo broadcasts this switch must be set to the STEREO 
position. However if you are listening to a distant or weak FM Stereo station
and reception is unsatisfactory, setting the selector to the FM MONO 
position may provide some improvement.
PHONES 
Jack
The Stereo Headphone Jack is located on the left front panel. Connect a set of stereo headphones (not included) to this jack for private listening without disturbing others. The speakers are automatically disconnected when headphones are connected to the headphone jack.
IMPORTANT: When using headphones always set the volume control to a low level before you put the headphones on. Then put the headphones on and gradually increase the volume to a comfortable listening level.
1 1