Simplicity 14E manual Tools Required, Hardware Description, Attaching the Chipper Cone

Assembling the Chipper Shredder

GENERAL

All of the major assembly procedures on your new Chipper/Shredder were performed at the factory, and only the items listed in this section need to be taken care of to make your unit fully operational.

TOOLS REQUIRED

•1/2" Box Wrench or Socket

•7/16" Box Wrench or Socket

•1/4" Hex Wrench

•Phillips Screw Driver

•Hex (Allen) Wrench

HARDWARE DESCRIPTION

The hardware pack included with your unit contains the items listed below. (Additional hardware may be involved for other models.)

Description	Qty.
• BOLT, Hex Head 5/16-18 x 1	. 1
• BOLT, Hex Head 5/16-18 x 3/4	. 2
• BOLT, Hex Head 5/16-18 x 1/2	. 2
• WASHER, Flat 5/16	. 4
• LOCKWASHER, 5/16	. 2
• CAPSCREW, Hex Socket 1/4-20 x 3/4 . . . . 6
• NUT, Flange (Whiz-lock) 1/4-20	. 6
• WASHER, 1/4	. 4

Attaching the Chipper Cone

1.See Figure 2. Position the chipper cone assembly base onto the mounting casting and attach the cone using the hex socket screws (1/4-20 x 3/4”) and the 1/4” lock nuts provided.

2.Tighten lock nuts securely using a 7/16” wrench or socket.

Figure 2. Installing Chipper Cone

Attaching the Handle

1.Lift the hopper handle up until the outer holes in the handle align with the holes in the shredder hopper. See Figure 3.

2.Secure the Hopper Handle in position using 1/4-20 x 3/4 hex socket screws, and 1/4-20 Whiz nuts, insert- ing the screws from the outside of the hopper.

3.Tighten all four screws securely.

Figure 3. Installing the Hopper Handle

8