Starting a Warm Engine, Operating Position

WARNING: Remove fuel cap slowly when refueling.

This engine is certified to operate on un- leaded gasoline. Gasoline must be mixed with a good quality synthetic 2--cycle air-- cooled engine oil designed to be mixed at a ratio of 40:1. Poulan/Weed Eater brand syn- thetic oil is recommended. (A 40:1 ratio is ob- tained by mixing 3.2 ounces of oil with 1 gallon of unleaded gasoline). When mixing fuel fol- low the instructions printed on the container. Always read and follow the safety rules under

FUEL SAFETY.

SAllow engine to run 10 seconds, then move choke lever to OFF CHOKE position.

STARTING A WARM ENGINE

SMove choke lever to OFF CHOKE position. S Pull starter rope handle until engine runs. S If engine does not start in 5 pulls, follow instructions in STARTING A COLD ENGINE.

It is recommended that the engine not be operated for longer than 1 minute at full throttle.

OPERATING POSITION

ALWAYS WEAR:

Eye

Protection

HOW TO STOP YOUR UNIT

To stop the engine, push and release the en- gine STOP switch. The switch will automati- cally return to the ON position. Wait 5 sec- onds before attempting to restart unit to allow switch to reset.

HOW TO START YOUR UNIT

Starting Position

Long Pants

Heavy Shoes

Cut from your right to your left.

ADVANCING THE CUTTING LINE

Advance line by tapping the bottom of the cut- ting head lightly on the ground while engine is running at full speed. A metal blade attached to the shield will cut the line to the proper length.

TWIST-N-EDGE

SPull the tab toward the engine.

STwist the tube to the edging position; release the tab.

Choke lever

Trigger

Primer Bulb

Muffler

Tab

WARNING: The trimmer head will turn while starting the engine. A hot muffler can cause serious burns.

STARTING A COLD ENGINE (or a warm engine after running out of fuel)

SSet unit on a flat surface.

SSlowly press the primer bulb 6 times.

SMove choke lever to FULL CHOKE posi- tion.

S Squeeze the throttle trigger fully and hold through all remaining steps.

SPull starter rope handle sharply 6 times. S Move choke lever to HALF CHOKE posi-

tion.

S Pull starter rope handle no more than 6 pulls, until engine runs.

REPLACING THE LINE

SRemove spool by firmly pulling on tap but- ton.

SClean entire surface of hub and spool.

S Replace with a pre-wound spool, or cut a length of 20 feet of 0.080” (2 mm) diameter Weed Eaterr brand line. Never use wire, rope, string, etc., which can break off and become a dangerous missile.

SInsert one end of the line about 1/2 inch (1 cm) into the small hole on the inside of spool.

Small

Hole

Spool