Poulan 545117592, PPB350 instruction manual Seasonal Storage, Fuel System, Engine, Other

Page 13

The carburetor has been carefully set at the factory. Adjustments may be necessary if you notice any of the following conditions:

S Engine will not idle when the throttle is released.

S The trimmer head, blade or optional attachment moves/spins at idle.

Make adjustments with the unit supported so the cutting attachment is off the ground and will not make contact with any object. Hold the unit by hand while running and making ad- justments. Keep all parts of your body away from the cutting attachment and muffler.

Idle Speed Adjustment

Allow engine to idle. Adjust speed until engine runs without trimmer head, blade or optional attachment moving or spinning (idle too fast) or stalling (idle speed too slow).

S Turn idle speed screw clockwise to increase engine speed if engine stalls or dies.

STurn idle speed screw counterclockwise to decrease engine speed if trimmer head, blade or optional attachment moves or spins at idle.

WARNING: Recheck the idle speed after each adjustment. The trimmer head, blade or optional attachment must not move or spin at idle speed to avoid serious injury to the operator or others.

Air Filter Cover

Idle Speed Screw

If you require further assistance or are unsure about performing this procedure, contact an

authorized

service dealer or call

1--

800--

554--

6723.

STORAGE

WARNING: Perform the following steps after each use:

SAllow engine to cool before storing or trans- porting.

SStore unit and fuel in a well ventilated area where fuel vapors cannot reach sparks or open flames from water heaters, electric

motors or switches, furnaces, etc.

SStore unit with all guards in place. Position unit so that any sharp object cannot acci-

dentally cause injury.

SStore unit and fuel well out of the reach of children.

SEASONAL STORAGE

Prepare unit for storage at end of season or if it will not be used for 30 days or more.

If your unit is to be stored for a period of time: S Clean the entire unit before lengthy

storage.

SStore in a clean dry area.

SLightly oil external metal surfaces.

FUEL SYSTEM

Under FUELING ENGINE in the OPERA- TION section of this manual, see message la- beled IMPORTANT regarding the use of ga- sohol in your engine.

Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to the gasoline in the fuel tank or fuel storage container. Fol- low the mix instructions found on stabilizer container. Run engine at least 5 minutes after adding stabilizer.

HELPFUL TIP

During storage of your gas/ oil mixture, the oil will sepa- rate from the gas.

We recommend that you shake the gas can weekly to insure proper blending of the gas and oil.

ENGINE

SRemove spark plug and pour 1 teaspoon of

40:1, 2-cycle engine oil (air cooled) through the spark plug opening. Slowly pull the starter rope 8 to 10 times to distribute oil.

SReplace spark plug with new one of recom-

mended type and heat range.

SClean air filter.

S Check entire unit for loose screws, nuts, and bolts. Replace any damaged, broken, or worn parts.

SAt the beginning of the next season, use only fresh fuel having the proper gasoline to oil ratio.

OTHER

SDo not store gasoline from one season to

another.

SReplace your gasoline can if it starts to rust.

13

Image 13
Contents English Español Français Manual de Instrucciones Manuel d’InstructionsOperator Safety Safety RulesFuel Safety UNIT/MAINTENANCE SafetyCutting Safety Transporting and StorageAssembly Assembly Information Trimmer Head Configuring Your UnitAttaching the Plastic Shield and Trimmer Head Installation of the Metal Blade Assembly Information Weed BladeAttaching the Metal Shield Operation HOW to Start Your Unit HOW to Stop Your UnitSwitch Throttle Trigger Starting a Flooded Engine Starting a Warm EngineOperating Position Operating Instructions for USE with Trimmer HeadTip of the line Operating Instructions for USE with Weed BladeDoes the cutting Work area Inches 8 cm above groundInspect and Clean Unit and DE- Cals MaintenanceClean AIR Filter Check for Loose Fasteners and PartsService and Adjustments Seasonal Storage StorageFuel System EngineLoad Adjustment Troubleshooting Table Cause RemedyCompression low Carbon build-up onLigations The U.S. Environmental Limited WarrantyPlacement and Repair of Emission