Global Machinery Company LTP25SS Additional safety rules for petrol line trimmers, Unpacking

Page 5

Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users.

Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool’s operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools.

Keep cutting tools sharp and clean.

Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.

Use the power tool, accessories and tool bits etc., in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from intended could result in a hazardous situation.

Service

Have your power tool serviced by a qualified repair personnel using only identical replacement parts. This will ensure that the safety of the power tool is maintained.

Additional safety rules for petrol line trimmers

Do not operate in a hazardous location.

Such areas include where there is a risk of explosion of petrol fumes, leaking gas or explosive dust.

Do not operate in a confined area. Exhaust gases, smoke or fumes could reach dangerous concentrations.

Protect your tool. This line trimmer is NOT WEATHERPROOF and should not be exposed to direct sunlight, high ambient temperature and damp, wet or high humidity conditions.

Do not smoke while refuelling. This is potentially dangerous as it may ignite the fuel and cause an explosion.

Take care not to spill fuel. When refuelling the line trimmer ensure that the motor has been switched off. Prevent the spilling of fuel as this may also ignite with the hot motor. Never refuel whilst the engine running.

Be careful where you store the line trimmer. Store the line trimmer in a dry area away from flammable liquids.

Keep your distance. The line trimmer emits exhaust fumes. Ensure bystanders keep a safe distance.

Ensure you use oil-mix fuel. Ensure that you mix

40 parts unleaded fuel to 1 part 2-stroke oil. If not, the engine will overheat and cause damage to your line trimmer.

Use good quality air cooled 2-stroke engine oil.

Never fill fuel tank indoors. Never fill fuel tank when engine is running or hot. Do not smoke when filling fuel tank.

Wear goggles

Wear earmuffs

Wear a breathing mask

Unpacking

Due to modern mass production techniques, it is unlikely that your petrol line trimmer is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.

Contents of carton

Upper shaft with motor

Lower shaft

Safety guard with attaching bolt and nut

Hex key

Spark Plug Wrench

Bump feed spool

Fuel mixing canister

Carry Strap

5

Image 5
Contents 25.4CC Contents Choke control Environmental protection Description of symbolsIntroduction Personal safety SpecificationsSafety instructions Unpacking Additional safety rules for petrol line trimmersContents of carton Know your product Fitting the safety guard AssemblyJoining the shaft Fitting the spoolFitting the secondary handle Mixing the fuelStarting the line trimmer Filling The TankRunning in the engine Stopping the line trimmerUse of the petrol line trimmer Operating the line trimmerFeeding the line Replacement of the cutting lineAdvancing the line manually Tips for cuttingFuel Filter MaintenanceAir filter Servicing Storage and maintenance after useChecking the spark plug Power loss or sudden stopping of the engine ProblemsBad quality cut Line will not advancePage GMC customer assist