Fitting the secondary handle
WARNING. Before each use, ensure the secondary handle cannot swivel by tightening the secondary handle locking knob. Over time, the knob may vibrate loose.
1. | The line trimmer has been | ||
| |||
| handle facing in the opposite | position | |
| direction to where it must sit |
| |
| during use. |
| |
2. Rotate the secondary handle |
| ||
| by 180°. |
| |
|
|
|
|
|
|
|
|
|
|
| operational |
| rotate 180º |
| position |
|
|
|
|
3.Slide the 6mm x 35mm
long hex head bolt through both holes in the underside of the handle. Ensure the hex head of the bolt is fully located in the hex recess in the side of the handle.
4.Fit the small flat washer on the end of the thread and then secure the handle using the yellow knob to tighten on the previously fitted handle bolt. The handle can be positioned up and down the shaft to suit the operators comfort.
Mixing the fuel
MOTOR FUEL: MIX AT 40:1 ONLY
IMPORTANT. Use good quality air cooled
This product is powered by a
1.Use fresh unleaded petrol. You must use
2.Mix the petrol and oil in an approved container. Never mix fuel directly in the line trimmer fuel tank. Use the fuel mixing bottle included with this product.
Note. Mixing has been made easy by |
|
including markings on the container |
|
included. For example, if unleaded fuel | 40:1 |
is filled to the ‘400’ mark in the “GAS” |
column of the container, place oil in the container until it reaches the next mark (in the 40:1 OIL markings of the container). Therefore, 400ml of fuel would mean 10ml of oil must be added.
WARNING. Never use any type of
3.Mix the fuel thoroughly and also each time before fuelling.
4.Always
Note. The mixing bottle provided is NOT for the storage of fuel. This container is solely for mixing of fuel only.
Ensure to keep this container in a safe storage location, empty of fuel and out of reach of Children.
8