Gardena 8882 manual Troubleshooting

GB

	A	ATTENTION ! Damage to the hedge trimmer!
		V Never clean the hedge trimmer under running
		water or with a water jet (in particular a high
G		pressure water jet).
F	1. Clean the hedge trimmer with a damp cloth.
	2. Lubricate the trimmer blade G with a low viscosity oil (e.g.
	GARDENA spray-oil Art. 2366). Avoid contact of the oil with
	the plastic parts and wear gloves.
8. Troubleshooting
		DANGER ! Risk of physical injury!
G		Cutting injuries can be caused if the hedge trimmer
F	Adoes switch on unintentionally.
		V Remove the battery before troubleshooting
		(see 4. Initial Operation) and slide the protective
		cover F over the cutter blade G.
Fault	Possible cause		Remedy
Hedge trimmer does not start	Battery is flat.		v Charge battery (see
			4. Initial Operation).
	Battery not pushed onto		v Push battery onto the handle
	the handle properly.		and make sure that the
			locking buttons snaps in
			correctly.

	When rotating the cutting unit, it	v When rotating the cutting
	was not engaged at 0° or 90°.	unit, engage it at 0° or 90°.
	When tilting the swivel head, it	v When tilting the swivel head,
	was not engaged between 75°	engage it between 75° and
	and -45°.	-45°.
Hedge Trimmer does not	Hedge Trimmer overheats.	v Let Hedge Trimmer cool for
start / starts only briefly		30 seconds.
Hedge is not cleanly cut	Blade blunt or damaged.	v Have blade replaced by
		GARDENA-Service.
Charging indicator lamp does	Battery not plugged in	v Plug in battery charger and
not light up	properly.	charging cable properly.
Charging indicator lamp	A fault has occurred.	v Unplug and reinsert
flashes for more than		charging cable. The fault
1 hour		will be reset.
The battery can no longer	Battery is defective.	v Replace the battery
be charged		(Art. 8835 / 8839).
	Only the original GARDENA Replacement Battery 18 V
	(Art. 8835 / 8839) may be used. This can be obtained from
	your GARDENA dealer or directly from GARDENA Service.
Telescopic tube slips despite	Nut/s loose on clamping lever/s. v Tighten nut/s on clamping
clamped clamping lever /s		lever/s using a 10 mm
		spanner.

20