Flymo 600XT, 450, 510 manual How to Use, Caring for your Hedgetrimmer, Lubricating the Cutting Blade

Page 6

How to Use

How to Use your Hedgetrimmer

1.Inspect area to be cut before each use - remove objects which can be thrown or become entangled in the cutting blades.

2.Always keep the Hedgetrimmer in front of your body. Hold handle firmly with both hands and stand in a secure and stable position.

3.Allow the cutting blades to reach full speed before entering the material to be cut.

4.Always work going away from people and solid objects such as walls, large stones, trees, vehicles etc.

5.If blade stalls, immediately stop the Hedgetrimmer. Disconnect the Hedgetrimmer from the power source and clear jammed debris from the cutting blades. Inspect blades

and repair or replace as needed.

Top Cutting

Use a wide sweeping motion. (M) A slight down- ward tilt of the cutting blades in the direction of motion gives the best cutting results.

Side Cutting

When trimming the sides of the hedge, begin at the bottom and cut upwards (N), tapering the hedge inward at the top. This shape will expose more of the hedge, resulting in more uniformed growth.

M

N

Caring for your Hedgetrimmer

• WARNING

P

Disconnect from the mains electricity sup-

 

ply, before attempting any maintenance or

 

adjustment.

 

Cleaning (P)

1. Using a soft brush - remove debris from all air intakes and cutting blade.

2.Wipe over surface of your hedgetrimmer with a dry cloth.

• IMPORTANT

Never use water for cleaning your hed- getrimmer. Do not clean with chemicals, including petrol, or solvents - some can destroy critical plastic parts.

Lubricating the Cutting Blade

For easier operation and longer life, lubricate the cutter blades before and after use. Apply the oil so that it runs between the two blades. (R).

At the end of the Cutting Season.

1.Clean your Hedgetrimmer thoroughly.

2.Check that all nuts and bolts are secure.

3.Visually inspect the Hedgetrimmer for any worn or damaged parts, contact your local Service Centre if any parts require replacement.

To store your Hedgetrimmer

Ensure the blade cover is fitted before storage.

Store in a dry place where your Hedgetrimmer is protected from damage.

R

Image 6
Contents EasiCut 420/EasiCut EasiCut 600XT Carton Contents SafetyExplanation of Symbols on your product Electrical Maintenance and storageGeneral PreparationMaximum rating AssemblyAssembly of Handguard Ensure the mains voltage suits your productTo start your Hedgetrimmer EasiCut 420/450/510 Before UseStarting and Stopping To start your Hedgetrimmer EasiCut 600XTLubricating the Cutting Blade How to UseCaring for your Hedgetrimmer At the end of the Cutting SeasonFailures not covered by guarantee Fault Finding HintsGuarantee & Guarantee Policy Environmental InformationService Recommendations EC Declaration of ConformityAll of the centres listed stock genuine Flymo Spare Parts