Carton Contents
start/stop lever |
| switchbox | |
|
| ||
cable clip |
|
| |
|
|
| upper handle |
|
| washers |
|
bolt |
|
|
|
handle knob |
| bolt |
|
cable clip | nut |
| electric cable |
| handle knob | with moulded | |
|
| ||
|
| on plug | |
|
|
| |
|
| lower handle |
|
fixing pin |
| instruction |
|
|
|
| |
|
| manual |
|
| fixing |
| |
| pin |
| plastic |
|
|
| cutters |
IMPORTANT !
Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
IF ANY PARTS ARE MISSING CONTACT:-
Electrolux Outdoor Products Customer Service Department direct
Telephone : 01325 300303, Fax : 01325 318193
Safety
If not used properly this product can be dangerous! This product can cause serious injury to the oper- ator and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this product. The operator is responsible for following the warning and safety instructions in this manual and on the product.
Explanation of Symbols on the Hover Vac
Warning
Read the user instructions carefully to make sure you understand all the con- trols and what they do.
Switch off! Remove plug from mains before adjusting, cleaning or if cable is entangled or damaged. Keep the cable away from the cutting parts.
Keep bystanders away. Do not operate whilst people especially children or pets are in the area.
Do not operate in the rain or leave the product outdoors while it is raining.
The use of eye protection is recommend- ed to protect against objects thrown by the cutting parts.
General
1.Never allow children or people unfamiliar with these instructions to use the product. Local regulations may restrict the age of the operator.
2.Only use the product in the manner and for the functions described in these instructions.
3.Never operate the product when you are tired, ill or under the influence of alcohol, drugs or medicine.
4.The operator or user is responsible for accidents or hazards occurring to other people or their property.
Electrical
1.The British Standards Institute recommend the use of a Residual Current Device (R.C.D.) with a trip- ping current of not more than 30mA. Even with a R.C.D. installed 100% safety cannot be guaranteed and safe working practice must be followed at all times. Check your R.C.D. every time you use it.
2.Before use, examine cable for damage, replace it if there are signs of damage or ageing.
3.Do not use the product if the electric cables are damaged or worn.