Grassbox | |
• For optimum performance your product is | P |
designed to be used with the grassbox fitted. | grassbox is full |
Grassbox full Indicator (P) |
|
• IMPORTANT |
|
The machine must be switched on for the | grassbox is empty |
grassbox full indicator to operate. |
|
1.When the ball reaches the top of the indicator win- dow, it is time to empty the grassbox. See figure N.
2.When the ball is NOT visible in the indicator win- dow, grass is being collected. See figure N.
Emptying the Grassbox (Q) | Q | |
• | Stop the product and wait until the cutting head |
|
| has stopped rotating before emptying the grass- |
|
| box. |
|
1. | Remove the grassbox lid. |
|
2. | Lift the grassbox off the product and empty. |
|
3. | Replace grassbox and lid carefully. |
|
• | Failure to fit the grassbox and lid correctly will |
|
| cause poor collection of grass clippings. |
|
Cutting System Maintenance
•Always handle the plastic cutters with care - sharp edges could cause injury. USE GLOVES.
Checking your Cutting System (R)
•The cutting system must be kept in good condition and inspected before and after use.
•Disconnect from the mains electricity supply and wait until the cutting head has stopped rotating. Turn your product upside down.
1.Visually check cutting head for wear. Replace if damaged.
2.Visually check plastic cutters for wear and replace when necessary.
3.Plastic cutters should be straight. Replace if bent
or twisted.
Replacing Plastic cutters (S)
•Use only genuine Flymo replacement plastic cutters specified for this product. These are available from all Electrolux Outdoor Products Service Centres and major retail outlets.
•Plastic cutters must be replaced in pairs to retain balance.
•Two plastic cutters of the same type should be fitted.
•Never fit a metal bar blade to this product.
To Replace Plastic Cutters
R
plastic
cutters
cutting head
fan
hood 
S
•Disconnect from the mains electricity supply and wait until the cutting head has stopped rotating. Turn your product upside down.
1.Push plastic cutter towards centre of cutting disc. Lift plastic cutter away from cutting head. (T)
2.If the plastic cutter is broken during use - lever cut- ter out of the slot, and dispose of carefully.
3.Fit new plastic cutters into the slots at each side of the cutting head and pull into place. (V)
•IMPORTANT ENSURE PLASTIC CUTTERS ARE CORRECTLY LOCATED.
T |
V |