Poulan 545123431 instruction manual Seasonal Storage, Fuel System, Engine, Other, Porting

Page 14

STORAGE

WARNING: Perform the following steps after each use:

SAllow engine to cool before storing or trans-

porting.

SStore unit and fuel in a well ventilated area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc.

SStore unit with all guards in place. Position unit so that any sharp object cannot acci- dentally cause injury.

SStore unit and fuel well out of the reach of children.

SEASONAL STORAGE

Prepare unit for storage at end of season or if it will not be used for 30 days or more.

If your unit is to be stored for a period of time: S Clean the entire unit before lengthy

storage.

SStore in a clean dry area.

SLightly oil external metal surfaces.

FUEL SYSTEM

Under FUELING ENGINE in the OPERA- TION section of this manual, see message la- beled IMPORTANT regarding the use of ga- sohol in your engine.

Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to the gasoline in the fuel tank or fuel storage container. Fol- low the mix instructions found on stabilizer container. Run engine at least 5 minutes after adding stabilizer.

HELPFUL TIP

During storage of your gas/ oil mixture, the oil will sepa- rate from the gas.

We recommend that you shake the gas can weekly to insure proper blending of the gas and oil.

ENGINE

SRemove spark plug and pour 1 teaspoon of 40:1, 2-cycle engine oil (air cooled) through

the spark plug opening. Slowly pull the starter rope 8 to 10 times to distribute oil.

SReplace spark plug with new one of recom-

mended type and heat range.

SClean air filter.

S Check entire unit for loose screws, nuts, and bolts. Replace any damaged, broken, or worn parts.

SAt the beginning of the next season, use only fresh fuel having the proper gasoline to oil ratio.

OTHER

SDo not store gasoline from one season to another.

SReplace your gasoline can if it starts to rust.

14

Image 14
Contents PPB200 UL Classified Product Notice Safety RulesOperator Safety Line Trimmer Safety Unit / Maintenance SafetyFuel Safety Additional Safety RulesBrushcutter Safety Edger SafetyBLOWER/VACUUM Safety Always use the handlebar when using edger attachmentPole Pruner Safety Cultivator SafetyHedge Trimmer Safety Know how to stop quickly Snow Thrower SafetyHigh speed causing injury Keep the rotor clear of debrisAdjusting the Handle AssemblyInstalling Trimmer ATTACH- Ment Attaching the ShieldOperation Starting a Warm Engine HOW to Start Your UnitSwitch Starting a Flooded EngineRemoving Trimmer ATTACH- Ment or Other Optional Attachments Installing Optional ATTACH- MentsOperating the Coupler Operating PositionTip of the line Trimmer Line AdvanceCutting Methods Does the cutting Work areaMaintenance Replacing the Line Service and AdjustmentsCarburetor Adjustment Replacing the Cutting HeadEngine Seasonal StorageFuel System OtherTroubleshooting Table Cause Remedy Limited Warranty Ligations The U.S. EnvironmentalService Centers 800--554--6723