Poulan PP446E For Optional Attachments, Edger Safety, Line Trimmer Safety, BLOWER/VACUUM Safety

Page 5

SPECIAL NOTICE: This unit is equipped with a temperature limiting muffler and spark ar- resting screen which meets the requirements of California Codes 4442 and 4443. All U.S. forest land and the states of California, Idaho, Maine, Minnesota, New Jersey, Oregon, and Washing- ton require by law that many internal combus- tion engines be equipped with a spark arresting screen. If you operate in a locale where such regulations exist, you are legally responsible for maintaining the operating condition of these parts. Failure to do so is a violation of the law. For normal homeowner use, the muffler and spark arresting screen will not require any ser- vice. After 50 hours of use, we recommend that your muffler be serviced or replaced by an au- thorized service dealer.

ADDITIONAL SAFETY RULES

FOR OPTIONAL ATTACHMENTS

WARNING: For each optional at- tachment used, read entire instruction manu- al before use and follow all warnings and in- structions in manual and on attachment.

WARNING: Ensure handlebar is installed when using edger or brushcutter at- tachments. Attach handlebar above arrow on safety label on the upper shaft (engine end of unit). If your edger or brushcutter attachment does not include a handlebar, a handlebar ac- cessory kit (#530071451) is available from your authorized service dealer.

Keep children, bystanders, and animals 50 feet (15 meters) away. Stop unit immediately if ap- proached.

WARNING: Inspect the area to be trimmed before each use. Remove objects (rocks, broken glass, nails, wire, etc.) which can be thrown by or become entangled in line. Hard objects can damage the trimmer head and be thrown causing serious injury.

SUse only for trimming, scalping, mowing and sweeping. Do not use for edging, pruning or hedge trimming.

SCut from your right to your left. Cutting on left side of the shield will throw debris away from the operator.

EDGER SAFETY

WARNING: Inspect the area to be edged before each use. Remove objects (rocks, broken glass, nails, wire, etc.) which can be thrown by the blade or can wrap around the shaft.

SBlade rotates momentarily after the trigger

is released. The blade can seriously cut you or others.

SAllow blade to stop before removing it from the cut.

Handlebar

LINE TRIMMER SAFETY

DANGER: Never use blades with line trimmer attachment. Never use flailing de- vices with any attachment. Use of any other accessories with line trimmer attachment will increase the risk of injury.

WARNING: Trimmer line throws ob- jects violently. You and others can be blinded/in- jured. Wear eye and leg protection. Keep body parts clear of rotating line.

Eye Protection

SThrow away blades that are bent, warped, cracked, broken or damaged in any other way. Replace parts that are cracked, chipped, or damaged before using the unit.

SDo not attempt to remove cut material nor hold material to be cut when the engine is running or when cutting blade is moving.

SAlways keep the wheel and depth adjusting skid in contact with the ground.

S Always push the unit slowly over the ground. Stay alert for uneven sidewalks, holes in the terrain, large roots, etc.

SAlways use the handlebar when using edg- er attachment.

BLOWER/VACUUM SAFETY

WARNING: Inspect area before starting unit. Remove all debris and hard ob- jects such as rocks, glass, wire, etc. that can ricochet, be thrown, or otherwise cause injury or damage during operation.

S Do not set unit on any surface except a clean, hard area while engine is running.

Boots

HazardZone

50 ft.

(15 meters)

Debris such as gravel, sand, dust, grass, etc., could be picked up by the air intake and thrown out through discharge opening, damaging unit, property, or causing serious injury to bystanders or operator.

S Never place objects inside the blower tubes, vacuum tubes or blower outlet. Al- ways direct the blowing debris away from

5

Image 5
Contents PP446E Plan Ahead Identification of SymbolsSafety Rules Maintain Your Pruner in Good Working Order Operate Your Pruner SafelyHandle Fuel with Caution KickbackReduce the Chance Kickback Kickback Safety FeaturesMaintain Control TipLine Trimmer Safety Edger SafetyBLOWER/VACUUM Safety For Optional AttachmentsCultivator Safety Brushcutter SafetyProper air flow Curs, stop the engine and inspect the unit for damageSnow Thrower Safety Hedge Trimmer SafetyHead Essary before restarting unitInstalling Pruner ATTACH- Ment AssemblyShoulder Strap Assembly Tools RequiredOperation HOW to Start Your Unit HOW to Stop Your UnitBAR and Chain Lubrication Starting a Cold EngineInstalling Optional ATTACH- Ments Installing Attachment HangerOperating the Coupler Removing Pruner Attachment or Other Optional Attach MentsFoot Pruning Important PointsPruning Technique Maintenance Service and Adjustments Carburetor Adjustment Chain AdjustmentIdle Speed Adjustment To Replace ChainFuel System Seasonal StorageEngine OtherLoad Adjustment Troubleshooting Table Cause RemedyCompression low Carbon build-up onLigations The U.S. Environmental Limited Warranty800--554--6723 Service