Poulan 530163735 instruction manual HOW to Stop Your Unit, HOW to Start Your Unit

Page 10

S Never use waste oil for bar and chain lubrication.

S Always stop the engine before removing the oil cap.

IMPORTANT

Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during stor- age. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, empty the fuel system before stor- age for 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

See the STORAGE section for additional in- formation.

HOW TO STOP YOUR UNIT

S To stop the engine, move the ON/OFF switch to the OFF position.

SIf engine does not stop, move choke lever to the FULL CHOKE position.

ON/OFF Switch

HOW TO START YOUR UNIT

WARNING: Make sure the chain will not make contact with any object while start- ing the engine. Never try to start the unit when the guide bar is in a cut. Avoid any contact with the muffler. A hot muffler can cause seri- ous burns.

STARTING A COLD ENGINE (or a warm engine after running out of fuel)

Starting Position

Starter Handle

Choke

Lever

Primer Bulb

4.Move choke lever to FULL CHOKE by aligning lever with position shown on de- cal (see illustration below).

Choke position decal

5.Squeeze the throttle trigger fully and hold through all remaining steps.

6.Pull starter rope handle sharply until en- gine sounds as if it is trying to start, but do not pull rope more than 6 times.

7.As soon as engine sounds as if it is trying to start, move choke lever to HALF CHOKE by aligning lever with position shown on decal (see illustration below).

Choke position decal

8.Pull starter rope sharply until engine runs, but no more than 6 pulls. If the engine doesn’t start after 6 pulls (at the HALF CHOKE position), move the choke lever to the FULL CHOKE position and press the primer bulb 6 times. Squeeze and hold the throttle trigger and pull the starter rope 2 more times. Move the choke lever to the HALF CHOKE position and pull the starter rope until the engine runs, but no more than 6 pulls. If the engine doesn’t start, repeat procedure 2 additional times.

NOTE: If engine still doesn’t start, it is probably flooded. Proceed to STARTING A FLOODED ENGINE.

9.Once the engine starts, allow it to run 10 se- conds, then move the choke lever to OFF CHOKE by aligning lever with position shown on decal (see illustration below). Al- low the unit to run for 30 more seconds at OFF CHOKE before releasing the throttle trigger. NOTE: If engine dies with the choke lever in the OFF CHOKE position, move the choke lever to the HALF CHOKE position and pull the rope until engine runs, but no more than 6 pulls.

Muffler

1.Set unit on a flat surface.

2.Move ON/OFF switch to the ON position.

3.Slowly press the primer bulb 6 times.

Choke position decal

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents PP445 16/04Safety Rules Identification of SymbolsPlan Ahead Handle Fuel with Caution Operate Your Pruner SafelyMaintain Your Pruner in Good Working Order KickbackMaintain Control Kickback Safety FeaturesReduce the Chance Kickback Kickback danger zone on the bar tipBLOWER/VACUUM Safety Line Trimmer SafetyEdger Safety For Optional AttachmentsProper air flow Brushcutter SafetyCultivator Safety Curs, stop the engine and inspect the unit for damageHead Hedge Trimmer SafetySnow Thrower Safety Essary before restarting unitAssembly Operation See the Storage section for additional in- formation HOW to Stop Your UnitHOW to Start Your Unit Muffler Set unit on a flat surfaceStarting a Warm Engine Installing Optional ATTACH- MentsInstalling Attachment Hanger Starting a Flooded EnginePruning Technique MaintenancePruning Important Points Check for Loose Fasteners and PartsBAR Maintenance Inspect and Clean Unit and LA- BelsClean AIR Filter Check Chain TensionService and Adjustments Idle Speed Adjustment Chain AdjustmentCarburetor Adjustment Seasonal StorageCompression low Troubleshooting Table Cause RemedyLoad Adjustment Carbon build-up onEPA Emission Control Warranty Statement Limited WarrantyLigations The U. S. Environmental Intermediate 125 hours Extended 300 hours

530163735 specifications

The Poulan 530163735 is a versatile and powerful chainsaw designed to meet the demands of both homeowners and professionals. This remarkable tool is ideal for tasks such as cutting firewood, trimming trees, or clearing shrubs and is known for its reliability, performance, and user-friendly features.

One of the standout features of the Poulan 530163735 is its robust engine. This chainsaw is equipped with a powerful two-stroke engine that delivers efficient cutting performance while maintaining a manageable weight. The engine is engineered to provide a balance of power and fuel efficiency, allowing users to work longer without frequent refueling. The chainsaw also utilizes advanced technology that minimizes emissions, making it an environmentally friendly choice for those who value sustainability.

The chainsaw's cutting system features a durable chain and bar setup that can handle various cutting tasks with ease. The high-quality steel bar is designed for durability and longevity, ensuring that it withstands the rigors of regular use. Furthermore, the chainsaw's chain is engineered for precise cutting, allowing users to make clean and efficient cuts through wood of varying thickness.

Ergonomics play a significant role in the design of the Poulan 530163735. It features an anti-vibration system that reduces user fatigue, enabling longer periods of operation without discomfort. The handle is designed for a comfortable grip, providing excellent control during use. Additionally, chain tensioning is simplified, featuring a tool-free adjustment system that allows users to easily adjust the chain tension on the go.

Safety is paramount when using power tools, and this chainsaw incorporates several safety features to protect the user. The chain brake system is one such feature, which automatically stops the chain if the saw kicks back, reducing the risk of accidents. The chainsaw also includes a safety guard over the front handle, further enhancing user protection during operation.

In summary, the Poulan 530163735 chainsaw stands out for its powerful engine, efficient cutting capabilities, user-friendly design, and essential safety features. Whether you are a homeowner looking to maintain your property or a professional needing a reliable tool for various cutting tasks, this chainsaw delivers the performance and comfort necessary for effective wood cutting. With its combination of power, efficiency, and safety, the Poulan 530163735 is a commendable choice in the world of chainsaws.
Top Page Image Contents