Poulan PP333 instruction manual Seasonal Storage, Fuel System, Engine, Other, Porting

Page 19

STORAGE

WARNING: Perform the following steps after each use:

SAllow engine to cool before storing or trans-

porting.

SStore unit and fuel in a well ventilated area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc.

SStore unit with all guards in place. Position unit so that any sharp object cannot acci-

dentally cause injury.

SStore unit and fuel well out of the reach of children.

SEASONAL STORAGE

Prepare unit for storage at end of season or if it will not be used for 30 days or more.

If your unit is to be stored for a period of time: S Clean the entire unit before lengthy

storage.

SStore in a clean dry area.

SLightly oil external metal surfaces.

FUEL SYSTEM

Under FUELING ENGINE in the OPERA- TION section of this manual, see message la- beled IMPORTANT regarding the use of ga- sohol in your engine.

Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to the gasoline in the fuel tank or fuel storage container. Fol- low the mix instructions found on stabilizer container. Run engine at least 5 minutes after adding stabilizer.

HELPFUL TIP

During storage of your gas/ oil mixture, the oil will sepa- rate from the gas.

We recommend that you shake the gas can weekly to insure proper blending of the gas and oil.

ENGINE

SRemove spark plug and pour 1 teaspoon of 40:1, 2-cycle engine oil (air cooled) through the spark plug opening. Slowly pull the

starter rope 8 to 10 times to distribute oil.

SReplace spark plug with new one of recom-

mended type and heat range.

SClean air filter.

S Check entire unit for loose screws, nuts, and bolts. Replace any damaged, broken, or worn parts.

SAt the beginning of the next season, use only fresh fuel having the proper gasoline to oil ratio.

OTHER

SDo not store gasoline from one season to

another.

SReplace your gasoline can if it starts to rust.

19

Image 19
Contents Manual de Instrucciones Manuel d’Instructions Identification of Safety Symbols Table of ContentsHazard zone for thrown objects Optional Attachments Safety RulesOperator Safety Powerhead model Attachments Type Part. noTransporting and Storage UNIT/MAINTENANCE SafetyFuel Safety Cutting SafetyTools Required AssemblyCarton Contents Installing Brushcutter AttachmentTo Relocate Shoulder Strap Clamp Assembly of Shoulder StrapConfiguring Your Unit Assembly Information Trimmer HeadAttaching the Plastic Shield and Trimmer Head Assembly Information Weed BladeWeed Blade Attaching the Metal Shield Installation of the Metal BladeOperation Starting a Flooded Engine HOW to Stop Your UnitHOW to Start Your Unit Starting a Warm EngineCutting Methods Installing Optional ATTACH- MentsOperating Position Operating Instructions for USE with Trimmer HeadMowing Operating Instructions for USE with Weed BladeTrimming Scalping SweepingRecommended Cutting Position Additional Safety RulesEdger Safety BLOWER/VACUUM SafetyBreak glass, or cause other damage Cultivator SafetyHedge Trimmer Safety Pole Pruner SafetyOr when walking from one cutting location to another Snow Thrower SafetyKnow how to stop quickly Maintenance Replacing the Line Service and AdjustmentsBlade Replacement Carburetor Idle Speed AdjustmentOther Seasonal StorageFuel System EngineTroubleshooting Table Cause Remedy Ligations The U.S. Environmental Limited WarrantyCanada, contact Poulan PRONANCE, Replacement and Repair