Homelite UT20818 manual Handle, Grass Deflector

Page 7

ASSEMBLY

If your unit has been preassembled, check each step to make sure the unit has been properly assembled.

HANDLE

See Figure 4.

1.Remove the front handle, bolt, and wing nut from the Owner’s Kit.

2.Install the front handle onto the top side of the drive shaft housing and move it to a comfortable position.

3.Place the bolt through the front handle as shown, then install the wing nut.

4.Tighten wing nut securely.

GRASS DEFLECTOR

See Figure 5.

1.Remove wing nut, flat washer, lock washer, and bolt from the Owner’s Kit.

2.Place grass deflector over shaft and bracket.

3.Install bolt through the slots in the tabs on grass deflec- tor and bracket on driveshaft housing.

4.Install flat washer, lock washer and wing nut.

5.Tighten Securely.

Page

FRONT HANDLE

WING

NUT

BOLT

Fig. 4

BOLT	GRASS
	DEFLECTOR

BRACKET

LOCK WASHER

FLAT
WASHER	WING NUT	Fig. 5
	WING NUT

Image 7

Contents Operators Manual Important Safety Instructions Table of ContentsIntroduction Specific Safety Rules for Trimmer USE Symbol Name Explanation SymbolsInstructions SpecificationsFeatures UnpackingAttaching the Storage Hanger AssemblyAttaching the Power Head to the Trimmer Attachment Removing the Attachment from the Power HeadGrass Deflector HandleFueling and Refueling the Trimmer OperaOperating the Trimmer Cutting Tips OperationAdvancing the String CUT OFF BladeTo Start a Warm Engine Starting and StoppingSee To Start a Cold EngineSee Figures 10 MaintenanceSpool Replacement EZ Line TAP Advance System NEW Prewound SpoolCleaning the Exhaust Port and Muffler Spark Arrestor String ReplacementSee Figures 12, 13, 14, Storing the Trimmer 1 Month or Longer Replacing and Cleaning AIR FilterFuel CAP Spark PlugProblem Possible Cause Solution TroubleshootingSpeed. See Figure Idle Speed Screw Mixture Needle Limited Warranty Statement WarrantyWarranty Emissions Maintenance Schedule and Warranted Parts List Description Service PartsCalifornia Proposition Service Repair Parts