Homelite GS120V manual Operation, Charging Your Battery Pack

Page 8

OPERATION

WARNING:

If any parts are missing, do not operate unit until the missing parts are replaced. Failure to do so could result in possible serious personal injury.

BATTERY PACK

The battery pack for your tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it overnight prior to use. NOTE: Batteries will not reach full charge the first time they are charged. Allow several cycles (trimming followed by recharging) for them to become fully charged.

CHARGING YOUR BATTERY PACK

See Figure 2.

Charge battery pack only with the charging assembly provided.

Make sure power supply is normal household voltage, 120 volts, 60 Hz, AC only.

Connect charging assembly to power supply.

Place battery pack in charging assembly. Align raised rib on battery pack with groove in charging assembly. See Figure 2.

Press down on battery pack to be sure contacts on battery pack engage properly with contacts in charging assembly. When properly connected, red light on charging stand will turn on.

NOTE: During the two year warranty period, if the charge indicator light (LED) fails to come on or goes out while charging battery pack, return charging assembly and battery pack to your nearest Authorized Homelite Service Center for repair or replacing.

After normal usage, 3 hours or less of charging time is required to fully recharge battery pack. NOTE: If battery pack is completely discharged, 6 hours or longer of charging time is required to fully recharge battery pack.

When battery pack has been charged, disconnect charging assembly from power supply and remove the battery pack. This practice will increase battery life.

The battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem.

DO NOT place charger in an area of extreme heat or cold. It will work best at normal room temperature.

BATTERY

PACK

CHARGING

ASSEMBLY

RED

LIGHT (LED)

Fig. 2

IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES

When using your grass shear continuously, the batteries in your battery pack will become hot. You should let a hot battery pack cool down for approxi- mately 30 minutes before attempting to recharge. NOTE: This situation only occurs when continuous use of your grass shear causes the batteries to become hot. It does not occur under normal circum- stances. Refer to “CHARGING BATTERY PACK” for normal recharging of batteries. If the charger does not charge your battery pack under normal circum- stances, return both the battery pack and charger assembly to your nearest Authorized Homelite Ser- vice Center for electrical check.

Page 8

Image 8
Contents Operators Manual 12V Cordless Grass Shear Model NO. GS120V Thank YOU for Buying this Homelite Cordless Grass ShearTable of Contents Rules for Safe OperationWhile Operating Read ALL InstructionsBefore Operating Service Battery SafetyCharger Safety Safety Symbols Features Model GS120V 12V Cordless Grass ShearBattery Pack Charging Your Battery PackOperation Important Information for Recharging HOT BatteriesTo Install Battery Pack To Remove Battery PackStarting the Grass Shear Stopping the Grass ShearOperating Tips Using the Grass ShearHolding the Grass Shear Maintenance and Repair Blade Maintenance Grass ShearReplacing Blades Blade CareGrass Shear Lubrication BatteriesStoring the Grass Shear Cleaning the Grass ShearDisposal of the Exhausted Battery Pack Maintenanceand Repair TroubleshootingProduct Specifications GS120V Grass Shear SpecificationsHomelite Products Limited Warranty Homelite Consumer PRODUCTS, INC Service Model NO. and Serial noHOW to Order Repair Parts