Husqvarna H348SG owner manual Rear Drawbar See Fig, Support Assembly See Fig

Page 5

ASSEMBLY

1

HANG SUPPORT ASSEMBLY ON

REAR DRAWBAR (See Fig. 1)

Determine the correct support assembly for your tractor. The support assemblies are marked "A" and "B".

Compare the drawbar illustrations below to the drawbar located at the rear of your tractor.

Use the support assembly indicated for your tractor and discard the other support assembly.

2

MOUNTING COVER ASSEMBLY TO

SUPPORT ASSEMBLY (See Fig. 2)

NOTE: For ease of assembly, you may wish to obtain the assistance of another person for mounting cover assembly to tractor.

1.Position cover assembly on ground behind tractor.

2.Lift and rotate cover to align cover brackets with support assembly tubes.

3.Slide cover assembly down onto the support tubes.

DRAWBAR A

DRAWBAR B

Use Support Assembly

Use Support Assembly

Marked "A"

Marked "B"

1.Slide flanges of support assembly into drawbar slots first, then, pivot backwards inserting pin into drawbar pin hole.

2.Be sure support assembly is seated properly, then secure with retainer spring.

SUPPORT

ASSEMBLY

DRAWBAR SLOTS (Drawbar "A" shown)

INSERT

FLANGES

FIRST INTO

DRAWBAR

SLOTS

 

 

PIN

DRAWBAR

 

 

PIN HOLE

FIG. 1

RETAINER

 

 

 

SPRING

COVER ASSEMBLY

SUPPORT

ASSEMBLY

03024

FIG. 2

5

Image 5
Contents Model Number H348SG Product No 73 Inch Mower Grass Catcher Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationTable of Contents Parts Identification Carton ContentsKnow Your Grass Catcher Rear Drawbar See Fig AssemblySupport Assembly See Fig Lower Chute See Fig Container Mounting See FigLevel Mower Deck Upper Chute See Figs a and 5BTips for Improved Bagging Operation OperationBlade Care MAINTENANCE, Service or Adjust MentsCustomer Responsibilities KEY Part Description Repair Parts