Husqvarna 952711948 manual Spark plug, Two--piece shaft, Air filter, Cleaning the air filter

Page 18

MAINTENANCE

WARNING: Mufflers fitted with catalytic converters get very hot during use and remain so for some time after stopping. This also applies at idle speed. Contact can result in burns to the skin. Re- member the risk of fire!

WARNING: The inside of the muffler contain chemicals that may be carcinogenic. Avoid contact with these elements in the event of a damaged muffler.

WARNING: Bear in mind that: Engine exhaust fumes contain car- bon monoxide, which can cause carbon monoxide poisoning. For this reason you should not start or run the machine indoors, or any- where that is poorly ventilated. The exhaust fumes from the engine are hot and may contain sparks which can start a fire. Never start the machine indoors or near com- bustible material!

Spark plug

The spark plug condition is influenced by:

SIncorrect carburetor adjustment.

SAn incorrect fuel mixture (too much or in- correct type of oil).

SA dirty air filter.

These factors cause deposits on the spark plug electrodes, which may result in operat- ing problems and starting difficulties.

If the machine is low on power, difficult to start or runs poorly at idle speed: always check the spark plug first before taking any further action. If the spark plug is dirty, clean it and check that the electrode gap is 0,6 mm. The spark plug should be replaced after about a month in operation or earlier if necessary.

0,6 mm

CAUTION! Always use the recommended spark plug type! Use of the wrong spark plug can damage the piston/cylinder.

Two--piece shaft

The drive shaft end in the lower shaft should be lubricated with grease every 30 hours. There is a risk that the drive shaft ends (splined coupling) will seize if they are not lubricated regularly.

Air filter

The air filter must be regularly cleaned to remove dust and dirt in order to avoid:

SCarburetor malfunctions S Starting problems

S Loss of engine power

S Unnecessary wear to engine parts S Excessive fuel consumption

Clean the filter every 25 hours, or more regularly if conditions are exceptionally dusty.

Cleaning the air filter

Remove the air filter cover and take out the filter. Wash it clean in warm, soapy water. Rinse thoroughly. Ensure that the filter is dry before refitting it.

An air filter that has been in use for a long time cannot be cleaned completely. The filter must therefore be replaced with a new one at regular intervals. A damaged air filter must always be replaced.

115299326 Rev. 2 7/15/10

English--- 18

Image 18
Contents EN 2-24 FR 25-47 ES Symbol Explanation SymbolsContents What is WHAT? Know your trimmerGeneral Safety Precautions Personal protective equipmentClothing Machine’s safety equipmentThrottle lock-out First AID KITStop switch Cutting attachment guardMuffler Cutting equipment Trimmer headFitting the loop handle AssemblyAssembly Assembling and dismantling the two--piece shaftFitting the trimmer guard and trimmer head Fuel safety Fuel HandlingFuel Fueling MixingStarting and stopping Starting and StoppingCheck before starting Cold engineWarm engine Stopping General working instructions Basic safety rules Working Techniques Basic working techniquesSweeping ClearingCutting Stop the machine immediately if anyone approachesCarburetor MaintenanceUnit/Maintenance Safety MufflerTwo--piece shaft Cleaning the air filterSpark plug Air filterBevel gear Maintenance schedule Maintenance Daily Weekly Monthly Maintenance MaintenanceTechnical Data Technical dataAttachments Part. no Declaration of ConformityType EC Declaration of Conformity Only applies to EuropeTrimmer Head Line Loading Instructions Plastic Blades Tri Cut