Husqvarna 322L, 325L, 322C manual Vibration damping system, Muffler, Cutting Equipment, Locking nut

Page 5

SAFETY INSTRUCTIONS

4.Vibration damping system

Your machine is equipped with a vibration damping system, which is designed to give as vibration-free and comfortable use as possible.

Use of incorrectly wound cord or incorrect cutting equipment increases the level of vibration.

The machine’s vibration damping system reduces the transfer of vibrations between the engine unit/ cutting equipment and the machine’s handle unit.

!WARNING!

Over exposure to vibrations can result in blood-vessel or nerve injury to persons suffering with blood circulation problems. Seek medical attention if you experience physical symptoms that can be related to over exposure to vibrations. Examples of such symptoms are “numbness“, lack of feeling, “tickling“, “pricking“, “pain“ lack of or a reduction in normal strength, changes in the colour of the skin or its surfaces. These symptoms normally appear in the fingers, hands or wrists.

5. Muffler

The muffler is designed to give the lowest possible noise level and to direct the engine‘s exhaust fumes away from the operator. Muffler fitted with catalytic converter is also designed to reduce harmful exhaust components.

In countries that have a warm and dry climate the risk of fire is obvious. We have therefore fitted certain mufflers with a spark arrest screen. Make sure that your muffler is fitted with this kind of screen.

It is extremely important that the instructions for checking, maintaining and servicing the muffler are followed. (see the section “Control, maintenance and service of the machine‘s safety equipment“).

!WARNING!

Mufflers fitted with catalytic converters become extremely hot during use and after stopping. This also applies at idling speeds. Contact can result in burns to the skin. Be observant to the risk of fire!

!WARNING!

Bear in mind that exhaust fumes:

•contain carbon monoxide, which can cause carbon monoxide poisoning. Therefore never start or run the machine indoors.

•are hot and can contain sparks that can cause fires. Never start the machine indoors or close to inflammable material.

6.Cutting

equipment

The trimmer head is intended for trimming grass.

7. Locking nut

A locking nut is used to secure some types of cutting equipment on the output shaft.

English – 5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents 101 91 322C325L 322L325C 325L325CMax 10000 rpm Symbol ExplanationSymbols Contents Personal protective equipment Safety InstructionsMachine‘s safety equipment Muffler Vibration damping systemCutting Equipment Locking nutMaintenance Trimmer head Cutting equipmentFuel safety General safety instructionsStart Transport and storageGrass trimming using the trimmer head and plastic knifes Basic safety precautionsGeneral working instructions Basic working techniquesSweeping ClearingTrimming What is what on the trimmer? What is WHAT?Assembly of the trimmer head AssemblyAssembling the loop handlebar 322C, 325CX Assembling the loop handlebar 322L, 325L-X/L-XTFit the appropriate guard Fitting the spray guard and trimmer head 322CFitting the spray guard and trimmer head 325CX Fuelling Fuel HandlingFuel mixture Start and stop Start and StopControl before starting Carburetor MaintenanceHigh speed needle Final setting of the idling speed TCorrectly adjusted carburetor Two-part shaft Muffler Cooling systemSpark plug Angle gear 322L, 325L-X/L-XT Maintenance scheduleAir filter Technical data 322C 322L 325L-X/L-XT Technical DataType Cutting attachment guard Art No Technical data 325CXYour Warranty Rights Obligations Emission Control Warranty StatementSuper Auto Super Auto II Tri Cut Trimmy H Click Trimmy Hit Junior Trimmy Hit Pro 12 cm Trimmy SII 502 26 Trimmy ´*313¶5r¨ Page 2001W15
Top Page Image Contents