ASSEMBLY
Fitting the hand guard and loop handle
(325HDA55,323HE3,325HE3)
1Assemble the hand guard and loop handle by screwing them together. Take care to align the holes in both parts.
2Slide the loop handle and hand guard onto the shaft.
3Slide the spacer into the slot in the loop handle.
4Fit the nut and screw. Do not overtighten.
5Now make a final adjustment to give yourself a comfortable working position. Tighten the screw. CAUTION! The loop handle and hand guard must not be fitted behind the arrow marked on the shaft.
Fitting the handle
(323HE3, 325HE3,325HE4)
Fit the handle using two screws.
Fitting the cutting head
It is important that the hedge trimmer is laid on a flat surface when you fit the cutting head. Otherwise the cutting head may not be fitted straight.
1Fit the cutting head to the shaft. CAUTION! Make sure the drive shaft inside the shaft engages with the recess in the cutting head.
2 Tighten the lower screw first, then the upper screw.
Adjusting the harness
(325HE4)
You should always use the harness with the machine to give maximum control over the machine and reduce the risk of fatigue in your arms and back.
1Put on the harness.
2Hook the machine onto the harness support hook.
3Adjust the length of the harness so that the support hook is roughly level with your right hip.
Fitting the impact guard
(325HE4)
Fit the guard using the three screws and washers. Fit the two short screws in hole A. Tighten the screws to a torque of 4 Nm. After the machine has been in use for around 20 hours,
10 – English